Invacare TER Owners Manual - Page 55

SECTION 7-FOOTREST/ANTI-TIPPER Adjusting the Transformer Footrests NOTE: For this procedure, refer to FIGURE 7.4. Depth 1. Remove the two mounting screws and locknuts that secure the footrest to the footrest clamp. 2. Move footrest to desired depth. 3. Align the holes in the footrest with the holes in the footrest clamp. 4. Secure footrest to footrest clamp with two mounting screws. Securely tighten. Angle 1. Loosen the two mounting screws in the footrest. 2. Adjust the angle of the footrest. 3. Retighten the two mounting screws. Tighten securely. Depth Mounting Screws Angle Footrest Mounting Screws Footrest Footrest Clamp Locknuts Depth Adjustment Holes Footrest FIGURE 7.4 Adjusting the Transformer Footrests Height 1. Note the order of the mounting screw, coved washers, spacer, half clamps and mounting screw/threaded sleeve and their position on the wheelchair frame and footrest tubing. 2. Remove the mounting screw, coved washers, spacer, half clamps and mounting screw/threaded sleeve on both sides of the wheelchair. 3. Choose an adjustment hole on the footrest tubing that will raise or lower the footrest to the desired position. 4. Reinstall the mounting screw, coved washers, spacer, half clamps and mounting screw/threaded sleeve on both sides of the wheelchair. Tighten securely. Mounting Screw/ Threaded Sleeve Coved Washer Footrest Tubing Adjustment Holes Half Clamp Mounting Screw Half Clamp Coved Washer Part No 1122172 FIGURE 7.5 Adjusting the Transformer Footrests Height 55 Everyday Series Wheelchairs/Sport Series Wheelchairs