JVC DR-DX5S Instruction Manual - Page 18

18 EN INSTALLING YOUR NEW UNIT Basic Connections Antenna or Cable Coaxial cable AC outlet Flat feeder AC power cord Matching transformer (not supplied) To [ANTENNA IN] Back of unit To [COMPONENT VIDEO OUT (Y/PB/PR)] Component video cable (not supplied) To [S-VIDEO OUTPUT] To [AUDIO/ VIDEO OUT] S-video cable Audio/Video (not supplied) cable (supplied) To [ANTENNA OUT] RF cable (supplied) TV It's essential that your unit be properly connected. ATTENTION: Connect the AC plug only after all connections to the TV has been completed. THESE STEPS MUST BE COMPLETED BEFORE ANY VIDEO OPERATION CAN BE PERFORMED. 1 Make sure the package contains all of the accessories listed in ASPECIFICATIONSB (A pg. 84). 2 Place the unit on a stable, horizontal surface. 3 Connect the unit to a TV depending on the TV and cables you use. 8 AV Connection To connect to a TV with AV input connectors ^ A Disconnect the TV aerial cable from the TV. B Connect the TV antenna cable to the [ANTENNA IN] connector on the rear panel of the unit. C Connect the [ANTENNA OUT] connector on the rear panel of the unit and the TV's antenna connector with the supplied RF cable. D Connect the supplied Audio/Video cable between the [AUDIO/ VIDEO OUTPUT] connectors on the rear panel of the unit and the TV's audio/video input connectors. NOTE: The [ANTENNA OUT] connector is only used to pass antenna signal to the TV. It is necessary to connect the [AUDIO/VIDEO OUTPUT] connectors to the TV to enjoy audio-visual programs. 8 S-Video Connection To connect to TV's S-VIDEO input and AUDIO input connectors ^ A Perform A - C of AAV ConnectionB in the left column. B Connect the unit's [S-VIDEO OUTPUT] connector to the TV's S-VIDEO input connector. C Connect the unit's [AUDIO OUTPUT] connectors to the TV's AUDIO input connectors. ● If your TV is not stereo-capable, use the unit's [AUDIO OUTPUT] connectors to connect to an audio amplifier for Hi-Fi stereo sound reproduction. NOTE: During DV playback, signal is output only from the connectors marked DV/HDD/DVD. 8 Component Video Connection To connect to TV's component video input connectors ^ A Perform A - C of AAV ConnectionB in the left column. B Connect the unit's [COMPONENT VIDEO OUT (Y/PB/PR)] connectors to the TV's component video input connectors. C Connect the unit's [AUDIO OUTPUT] connectors to the TV's AUDIO input connectors. ● You can obtain high-quality component video pictures. ● The [COMPONENT VIDEO OUT (Y/PB/PR)] connectors do not output DV signals. ● If your TV is not stereo-capable, use the unit's [AUDIO OUTPUT] connectors to connect to an audio amplifier for Hi-Fi stereo sound reproduction. ● By using the component video connection, you can view the images in the progressive mode. For switching to the progressive mode, refer to AScan Mode Set (HDD & DVD Deck Only)B (A pg. 76). 4 Plug the end of the AC power cord into an AC outlet. This unit performs Plug & Play Set automatically. (A pg. 19) ● The clock and tuner channels will automatically be set when the antenna is connected and when the AC power cord is first connected to an AC outlet. (If AAUTOB and the channel indicator are displayed on the front display panel before the unit is powered on, the clock and tuner channels are being set automatically. Wait for the time to be displayed on the front display panel before turning on the unit.) ● ALOADINGB blinks on the front display panel when the AC plug of the AC power cord is connected into a AC outlet and it takes approximately 50 seconds for the unit to be turned on. This is not a malfunction.