JVC DR-DX5S Instruction Manual - Page 65
Audio Dubbing (DV Deck Only
View all JVC DR-DX5S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 65 highlights
Audio Dubbing (DV Deck Only) This function allows you to record new audio, without erasing the original audio, on a DV tape that was recorded with ADV AUDIO RECB set to A12BITB (A pg. 71). ATTENTION: You cannot perform Audio Dubbing on a tape that was recorded with ADV AUDIO RECB set to A16BITB (A pg. 71), on a tape that was recorded at the ALPB speed, or on a blank tape. Your unit Recorder To [AUDIO] input CH +/- Audio cable (not supplied) AUDIO OUT CD player, etc. A.DUB CD player, etc. Mixer output Audio mixer EDITING EN 65 ● Slide the TV/CABLE/DBS/DVD switch to DVD. 1 Connect an audio device to the unit's [AUDIO] input connectors on the front panel. ● When using a monaural audio device, connect its AUDIO OUT connector to the [AUDIO-L] input connector on your unit. 2 Load a Mini DV cassette with the erase protection switch set to ARECB. 3 Press DV/HDD/DVD SELECT on the unit repeatedly or DV on the remote control so that the DV lamp lights up on the unit. 4 Press CH +/- to select AF-1B. 5 Start playback slightly before the actual point from where you wish to start dubbing. 6 Press W to pause playback. 7 Press A.DUB to engage the audio dubbing mode. ● Your unit enters the Audio Dubbing Pause mode. ● To perform Audio Dubbing with audio mixing, press AUDIO to select AL+RB at this point. When using the DV deck as the recording deck, also make sure that AAUDIO MODEB is set to ASOUND1B (A pg. 71). * Audio Dubbing with audio mixing is not possible if you are using a monaural audio component, or if you don't have an audio mixer. 8 Engage the audio device's playback, then press I to start the tape in the unit. Audio dubbing starts at this point. ● To stop dubbing temporarily, press W. Press I to resume dubbing. 9 Press o on the unit, then stop playback on the audio device to end the audio dubbing. NOTES: ● Once the Audio Dubbing starts, you cannot use the other deck. ● When monitoring the audio dubbed sound on the DV deck, set AAUDIO MODEB to ASOUND2B (A pg. 71). ● When playing back an audio dubbed Mini DV tape on the DV deck, set AAUDIO MODEB to ASOUND2B (A pg. 71). ● Audio dubbing is not possible using the [DV IN/OUT] connector. ● Audio dubbing is not possible on a blank portion of the tape. Your unit Original sound [AUDIO OUTPUT] Recorder To [AUDIO] input CH +/- A.DUB