JVC DR-DX5S Instruction Manual - Page 60

60 EN EDITING DV Dubbing (HDD & DVD Deck Only) You can dub programs from a camcorder or DV equipment connected to the unit with a DV cable. The unit's remote control allows you the limited control of the connected camcorder or DV equipment functions during dubbing. NOTES: ● When connecting the unit to a device equipped with a DV input connector, be sure to use the optional DV cable (VC-VDV 204U). ● When you connect a PC to the [DV IN] connector, we do not assure the normal operation of this unit. Your unit Camcorder DV equipment To [DV IN] DV cable (VC-VDV 204U) (not supplied) DV connector The following on-screen display for DV dubbing appears when ON SCREEN is pressed while the channel has been set to ADVB. FR360 12bit 0:00 HDD 00:00:00. 00 DV JVC 1:00 GR-DV3500 2:00 GR-DV3500 00:00:00. 00 DV L-R SOUND1 DV DV 12 AB C A Remote control switch To switch between the devices operable by the remote control unit. The unit is operable when the remote icon ( ) displayed faces to the left, while the DV device is operable when the remote icon is facing to the right. B Auto capture button Select to start or pause the dubbing. If ENTER is pressed when the DV device is in the pause condition, preroll editing* where it is possible to dub with a start time that is highly accurate will be activated. When the DV device cannot be operated from the unit (such as in camera mode), proceed with normal recording (A pg. 34, 37). ● Do not start dubbing at the portion with no time code (A- -:- -:- -B). * Preroll editing refers to the playback after the DV tape is slightly rewind. (For DV devices that do not support the -1x speed, the rewinding time may be longer.) C Sound monitor switch For selecting the desired sound format for dubbing. 1 Connect a camcorder or DV equipment to the [DV IN] connector on the unit's front panel. 2 Press DV/HDD/DVD SELECT on the unit repeatedly; or press HDD or DVD on the remote control to select the recording deck. ● When dubbing to a DVD disc, load a recordable disc on this unit. 3 Press CH +/- to set the channel to ADVB. 4 Press ON SCREEN. ● The on-screen display for DV dubbing appears. 5 Press selection keys to select , then press ENTER to display the remote icon (facing to the right) for the DV equipment. 6 Press REC MODE repeatedly to set the recording mode. For DV deck, press REC MODE on the remote control to set the recording mode. 7 Locate the point from where you want to start dubbing, then stop or pause playback by pressing the following buttons on the remote control: I, N, O, o, W. ● To play back in slow speed (1/10 of the normal speed), press W to pause playback, then press O or N. ● To play back frame-by-frame, press W to pause playback, then press W repeatedly. Each press of W advances a frame. ● To change the playback direction, press O or N. 8 Press selection keys to select , then press ENTER repeatedly until the desired sound track appears on the TV screen. SOUND1: Select this to record the original stereo sound played back on the connected DV equipment. SOUND2: Select this to record the dubbed stereo sound played back on the connected DV equipment. MIX: Select this to record the sound of both ASOUND1B and ASOUND2B. ● Note that this selection is not available when the source program is recorded in 16BIT (48 kHz) mode. 9 Press selection keys to select , then press ENTER. The dubbing starts. ● Playback on the external DV equipment and recording on the unit should start simultaneously.