JVC SR-VS20U 76 pg User's Manual on the SR-VS20U (1776KB, PDF) - Page 59

PLAY STOP PAUSE T 1 4 W 2 5 3 2 6 7 8 9 0 4 1 PLAY STOP DV S-VHS PAUSE 3 EN 59 START DUBBING 6 Engage the audio component's Play mode, then press PLAY to start the tape in your VCR. Audio dubbing begins at this point. ● When monitoring the audio-dubbed sound on the DV deck, set "12BIT MODE" to "SOUND2". (੬ pg. 33) ● blinks and is displayed on the front display panel. ● To stop dubbing temporarily, press PAUSE. Press PLAY to resume dubbing. END AUDIO DUBBING 7 Press STOP to stop the tape in your VCR, and engage the audio component's Stop mode. NOTES: ● Once the Audio Dubbing starts, you can not use the other deck. ● When monitoring the sound during Audio Dubbing, the normal soundtrack is automatically selected. If you wish to hear the Hi-Fi or mixed sound (Hi-Fi + Normal soundtracks), refer to the "Select The Soundtrack" section (੬ pg. 32) and select the soundtrack you wish to hear. (VHS deck only) ● Audio dubbing stops automatically when the counter reaches "0:00:00", and the VCR enters the Play mode. Check the counter reading before dubbing. (VHS deck only) ● Audio dubbing is also possible using the rear AUDIO IN connectors. ● Audio dubbing cannot be performed on a VHS/S-VHS cassette that has had its record safety tab removed, or on a Mini DV cassette that has had its erase protection switch set to "SAVE". ● When playing back an audio-dubbed tape on the VHS deck, refer to the "Select The Soundtrack" section (੬ pg. 32) to select the soundtrack you wish to hear. When playing back an audio-dubbed Mini DV tape on the DV deck, set "12BIT MODE" to "SOUND2" (੬ pg. 33). ● Picture may be distorted during Audio Dubbing Pause. ● It may be unlawful to record or play back copyrighted material without the consent of the copyright owner. ● Audio dubbing is not possible using the DV IN/OUT connector.