JVC SR-VS20U 76 pg User's Manual on the SR-VS20U (1776KB, PDF) - Page 69
Timer Recording, Recording
View all JVC SR-VS20U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 69 highlights
EN 69 RECORDING SYMPTOM 4. Audio dubbing is not possible. 5. Monitoring the audio-dubbed sound is not possible during audio dubbing using the DV deck. 6. The programmed memory of Random Assmble Editing is disappeared. 7. When performing Tape Dubbing, the beginning of the dubbing start point is not dubbed. TIMER RECORDING SYMPTOM 1. Timer recording won't work. 2. Timer programming won't work. 3. ‰ and ] on the front display panel won't stop blinking. 4. The cassette is automatically ejected, and ‰ and ] on the front display panel won't stop blinking. 5. ‰ blinks for 10 seconds and the timer mode is disengaged. 6. The cassette is automatically ejected, the power shuts off and ‰ and ] won't stop blinking. POSSIBLE CAUSE ● "SOUND MODE" on the DV Mode Set Menu had been set to "16BIT" at the original recording. ● The tape speed had been set to LP at the original recording. ● This is normal. ● The memory backup time has expired. ● This is normal. POSSIBLE CAUSE ● The clock and/or the timer have been set incorrectly. ● The timer is not engaged. ● The VCR has not been set up properly. ● Timer Recording may not work when the VCR's input mode is set to "F-1" for recording on the DV deck, because the recorder is waiting for the signals through DV IN/OUT (i.Link) connector. ● Timer recording is in progress. ● The timer is engaged but there's no cassette loaded. ● VHS deck The loaded cassette has had its Record Safety tab removed. ● DV deck The loaded cassette has had its erase protection switch set to "SAVE". ● TIMER has been pressed when there are no programs in memory, or the timer record program information has not been programmed correctly. ● The end of tape was reached during timer recording. CORRECTIVE ACTION Set "SOUND MODE" to "12BIT" at the original recording (੬ pg. 33). Set the tape speed to SP at the original recording. Monitor the sound using the connected devices. Perform Random Assemble Editing again. CORRECTIVE ACTION Set the clock and/or timer correctly. Press TIMER and check to make sure that ‰ appears on the front display panel. Re-perform the set-up procedures. Make sure you have compensated for Guide Channel and VCR or cable box channel number mismatches (੬ pg. 42). Set the channel position to "L-1" before engaging to Timer-Standby mode. Timer programming can't be performed when timer recording is in progress. Wait until it finishes. VHS deck Load a cassette with the Record Safety tab intact, or cover the hole using adhesive tape. DV deck Load a cassette with the erase protection switch set to "REC". Remove the cassette and cover the hole with adhesive tape, or insert a cassette with the Record Safety tab intact. Remove the cassette and set the erase protection switch to "REC". Check the programmed data and reprogram as necessary, then press TIMER again. The program may not have been recorded in its entirety. Next time make sure you have enough time on the tape to record the entire program. CONTINUED ON NEXT PAGE