JVC TK-C1460U Instruction Manual - Page 22
Auto white balance control adjustment
View all JVC TK-C1460U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
CONNECTION/INSTALLATION Auto white balance control adjustment Each light source has its own colour temperature. Therefore, when the main light source lighting an object is changed, the white balance should be adjusted again by pressing the AWC button. AWC button 1. Place a white object under the same lighting condition as the object to be shot and zoom in to fill the screen with white. SET AWC MENU CAMERA SETUP EXT TERM-OFF INT/GL DUPLEX RX TERM-OFF NOT USED ON LL SIMPLEX ON IRIS VIDEO DC 2. When the AWC button is pressed for approx. one sec., the white balance is adjusted for the object being recorded. 3. During the time when the Auto White function is operated, "AWC OPERATION" is displayed (for approx. 0.5 sec.). When the appropriate white balance is acquired, "AWC OK" is displayed. AWC OPERATION DURING OPERATION AWC NG : OBJECT OBJECT ERROR AWC OK DISPLAYING RESULT AWC ERROR : LOW LIGHT LOW LIGHTING 4. Error message display ● NG : OBJECT Displayed when there is not enough white colour on an object or the colour temperature is not suitable. By taking a shot of a white object to fill the screen, adjust the white balance again. ● ERROR : LOW LIGHT Displayed when the light is low. Increase the illumination then re-adjust the white balance. ● ERROR : HIGH LIGHT Displayed when the light is too bright. Decrease the illumination then re-adjust the white balance. AWC ERROR : HIGH LIGHT OVER LIGHTING MEMO Even if you press the AWC button, the white balance will not be re-adjusted during the operation in the black-and-white mode. E-22