Kenmore 9787 Installation Instructions - Page 13

Using a 4" (10.2 cm) clamp, connect vent to exhaust outlet in laundry center. If connecting to existing vent, make sure the vent is clean. The vent must fit over the exhaust outlet and inside the exhaust hood. Make sure the vent is secured to exhaust hood with a 4" (10.2 cm) clamp. Excessive Weight Hazard Use two or more people to move and install washer/dryer. Failure to do so can result in back or other injury. 2. Move laundry center into its final location. Do not crush or kink vent. Make sure laundry center is level. 3. Check that there are no kinks in the flexible gas line. 1. Check that all parts are now installed. If there is an extra part, go back through the steps to see which step was skipped. 2. Check that you have all of your tools. 3. Dispose of/recycle all packaging materials. Keep the plastic foam for use if the laundry center should be transported. 4. Check the laundry center's final location. Be sure the vent is not crushed or kinked. 5. Check that the laundry center is level and front leveling feet are tight. See "Level Laundry Center." 6= Plug into a grounded 3 prong outlet. Turn on power. 7. Check that the water faucets are on. 8. Check for leaks around faucets and inlet hoses. g. Remove the blue protective film on the console and any tape remaining on the laundry center. 10. Read the Laundry Center User Instructions. 11. Wipe the dryer drum interior thoroughly with a damp cloth to remove any dust. 12. To test the washer, measure 1/2the normal recommended amount of detergent and pour it into the washer. Close the lid. Select HEAVY DUTY and pull out the Cycle Control knob. Allow the washer to complete one whole cycle. 13. To test the dryer, set the dryer on a full heat cycle (not an air cycle) for 20 minutes and start the dryer. If the dryer will not start, check the following: • Laundry center is plugged into a grounded 3 prong outlet. • Start button has been pushed firmly. • Electrical supply is connected. • Household fuse is intact and tight, or circuit breaker has not tripped. • Dryer door is closed. 14. When the dryer has been running for 5 minutes, open the dryer door and feel for heat. If you do not feel heat, turn the dryer off and check to see that the gas supply line shutoff valve is open. • If the gas supply line shutoff valve is closed, open it, then repeat the 5-minute test as outlined above. • If the gas supply line shutoff valve is open, contact a qualified technician. Emectrica_ Shock Hazard Plug into a grounded 3 prong outlet. Do not remove ground prong. Do not use an adapter. Do not use an extension cord. Failure to follow these instructions can resumt in death, fire, or emectrica{ shock. 13