Kenmore 9787 Installation Instructions - Page 7

Fire Hazard Use a heavy metam vent, Do net use a pmastic vent, Do net use a metal foiB vent. _,_:,:_i!i/_:i(i_i!_i;!i_ii:::ili_b_i:i_ii_(iL!l!_i!i,!ii_,i}_(_i!i:il_i!i!Sii_ii'i!_ Flexible metal vent • Flexible metal vents are acceptable only if accessible for cleaning. • Flexible metal vent must be fully extended and supported when the dryer is in its final location. • Remove excess flexible metal vent to avoid sagging and kinking that may result in reduced airflow and poor performance. • Do not install flexible metal vent in enclosed walls, ceilings or floors. Elbows 45° elbows provide better airflow than 90° elbows. Failure to follow these instructions can resumt in death or fire. WARNING: To reduce the risk of fire, this laundry center MUST BE EXHAUSTED OUTDOORS. IMPORTANT: Observe all governing codes and ordinances. The dryer exhaust must not be connected into any gas vent, chimney, wall, ceiling, or a concealed space of a building. If using an existing vent system • Clean lint from the entire length of the system and make sure exhaust hood is not plugged with lint. • Replace any plastic or metal foil vent with rigid or flexible heavy metal vent. • Review Vent system chart. Modify existing vent system if necessary to achieve the best drying performance. If this is a new vent system Vent material • Use a heavy metal vent. Do not use plastic or metal foil vent. • 4" (10.2 cm) heavy metal exhaust vent and clamps must be used. DURASAFE TM venting products are recommended. Good Better Clamps Use clamps to seal all joints. Exhaust vent must not be connected or secured with screws or other fastening devices that extend into the interior of the duct. Do not use duct tape. Clamp Exhaust Recommended hood styles are shown here. 4" (!0.2 cm) heavymetal exhaust vent DURASAFE TM vent products can be purchased from your dealer. For further information, please call 1-800-4-MY-HOME ®(1-800-469-4663) or visit our website at www.sears.com, Rigid metal vent • For best drying performance, rigid metal vents are recommended. • Rigid metal vent is recommended to avoid crushing and kinking. _4 (1_4"_m) (10.2cm) A. Louvered hood style B. Box hood style The angled hood style (shown here) is acceptable. (10_2 cm_(_ _"_.4_2\1/'2' (6.4 cm}