Kenwood DDX370 Instruction Manual - Page 85
Removing the Unit, DDX470/DDX4070BT, DDX370/DDX3070 only, Installing the Microphone, Unit DDX790/
View all Kenwood DDX370 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 85 highlights
Removing the Unit (DDX470/DDX4070BT/ DDX370/DDX3070 only) • For removing DDX790/DDX770/DDX7070BT, ☞ page 80. 1 Remove the trim plate by referring to the removal procedure in the section "Removing the Trim plate". 2 Insert the two extraction keys 6 deeply into the slots on each side, as shown. Accessory 6 Installing the Microphone Unit (DDX790/DDX770/ DDX7070BT/DDX470/ DDX4070BT only) 1 Check the installation position of the microphone (accessory 9). 2 Remove oil and other dirt from the installation surface. 3 Install the microphone. 4 Wire the microphone cable up to the unit with it secured at several positions using tape or the like. ⁄ • Install the microphone as far as possible from the mobile phone. 3 Lower the extraction keys toward the bottom, and pull out the unit halfway while pressing towards the inside. Accessory 9 Fix a cable with clamps (commercially available). ⁄ • Be careful to avoid injury from the catch pins on the removal tool. 4 Pull the unit all the way out with your hands, being careful not to drop it. Peel the release coated paper of double-face adhesive tape to fix on the place shown above. Adjust the direction of the microphone to the driver. English 85