Kenwood KDC-X889 Instruction Manual - Page 14
Sound Field Control, Subwoofer Output
View all Kenwood KDC-X889 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
General features Subwoofer Output Turning the Subwoofer output ON or OFF. Hold down on [AM] of the Control knob for at least 1 second. Each time the button is pressed, Subwoofer output switches ON and OFF. When it's ON, "SW ON" is displayed. • You can control this item when (page 43) is set to "SWPRE Sub-W". (KDC-MP728/ MP628 only) • You can control this item when Speaker Select Subwoofer of (page 15) is set to any item other than "None". (KDC-X889/ MP828 only) • You can control this item when "2 ZONE" of (page 12/13) is set to "OFF". 4 Select the Sound Field Control item for adjustment Press the [1] - [3] and [5] button. Each time the [1] - [3] and [5] button is pressed, the adjustable audio items are switched among ranges of all stage section's tables on the following pages. Multi-function key operation [1] "XOver" [1] "Front"* [1] "Rear"* [1] "SW"* [2] "DTA" [2] "Front" [2] "Rear" [2] "SW" [3] "POSI" [5] "Preset" [1] "CALL" [2] "MEM" Sound Field control item High Pass Filter Front High Pass Filter Rear Low Pass Filter Subwoofer DTA Front DTA Rear DTA Subwoofer Position Setting Call mode Memory mode Function of the KDC-X889/KDC-MP828 Sound Field Control 1 Select the source for adjustment Press the [SRC] button. 2 Select the key function section Press the [NEXT] button. Repeatedly press the button until "S.F.C" is displayed above the [1] button. Refer to (page 9). 3 Enter Sound Field Control mode Press the [1] ("S.F.C") button. • When "2 ZONE" of (page 13) is ON, you cannot select "S.F.C". • * The following adjustment items can be selected by [FM] or [AM] knob for "XOver". [1] "XOver" [FM] or [AM] Knob "Front" Front High Pass Filter Center Front High Pass Filter Slope "Rear" Rear High Pass Filter Center Rear High Pass Filter Slope "SW" Subwoofer Low Pass Filter Center Subwoofer Low Pass Filter Slope Subwoofer Low Pass Filter Phase • "Preset": You can store an adjusted audio control value by selecting "MEM". Refer to (page 18). Also, you can recall it by selecting "CALL". Refer to (page 18). • "SW" can be adjusted when (page 14) is set to "SW ON" • Xover (Crossover Network Setup) You can manually set a crossover frequency of speakers. • DTA (Digital Time Alignment) Manually set the sound output timing of each channel. 14 | English