Konica Minolta bizhub C3100P bizhub C3100P Applied Functions User Guide - Page 49
[FTP Settings] - [FTP Server Settings], [SNMP Settings]
View all Konica Minolta bizhub C3100P manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 49 highlights
1.5 Available operations in Administrator mode 1 Item [User Name] [Password] [Realm] Description Enter the user name (using ASCII characters of up to 20 bytes, excluding a colon (:)). This entry is required if you have selected [Basic] or [Digest] in [IPP Authentication]. Enter the password (using ASCII characters of up to 20 bytes). To enter (change) the password, select the [Change Password] check box, then enter a new password. This entry is required if you have selected [Basic] or [Digest] in [IPP Authentication]. Enter the domain (realm) (using ASCII characters of up to 127 bytes). This entry is required if you have selected [Digest] in [IPP Authentication]. [FTP Settings] - [FTP Server Settings] To display: Administrator mode - [Network] - [FTP Settings] - [FTP Server Settings] To use application software with which the FTP server of this machine is used to communicate, configure the FTP server. Item [FTP Server] [Port Number] [Command Prohibit] [PORT Command Enhanced Security] Description Select whether or not to use the FTP server function of this machine. [Enable] is specified by default. If necessary, change the FTP server port number. [21] is specified by default. Select a command to deny a receiving job from an FTP client when using the FTP server of this machine. Set this option to return an error when a PORT/EPRT command or PASV/EPSV command is sent from an FTP client to this machine. [Allow] is specified by default. Select whether or not to enable this machine to run security measures against FTP bounce attacks. This option is not available if [Command Prohibit] is set to [PORT/EPRT]. When a PORT/EPRT command is sent from an FTP client, the data connection is established only if both of the following conditions are satisfied. • A port number less than 1024 is not specified. • The IP address specified by the command is same as that specified when a control connection is established. [Enable] is specified by default. [SNMP Settings] To display: Administrator mode - [Network] - [SNMP Settings] - [SNMP Settings] Configure the settings for obtaining the machine information and monitoring the machine using SNMP (Simple Network Management Protocol). Item [SNMP Settings] [SNMP] [SNMP v1/v2c (IP)] [SNMP v3 (IP)] [UDP Port] [SNMP v1/v2c Settings] Description Configure the SNMP settings. Select whether or not to use SNMP. [Enable] is specified by default. Select whether or not to use SNMP v1 or SNMP v2. [Enable] is specified by default. Select whether or not to use SNMP v3. [Enable] is specified by default. If necessary, change the UDP port number. [161] is specified by default. Configure the SNMP v1/v2c settings. [Applied Functions] 1-44