Kyocera FS-C2126MFP FS-C2126MFP Fax Operation Guide - Page 167

Setup and Registration Setting Reception Restriction You can restrict incoming faxes so that you only receive originals from senders registered in Permit FAX No. and Permit ID No. and senders registered in your Address Book. This mode also allows you to set a [Reject List] for Reception Restriction so that reception from senders on the list of Rejected FAX numbers or from senders whose Local FAX Number is not registered are rejected. To change the reception restriction, follow the steps below. 1 Refer to Basic Operation Procedure on page 6-7. TX/RX Restrict.: a b 1 TX Restriction *2**R*X**R*e*s*t*r*i*c*t*i*o*n***** 2 Press the U or V key to select [RX Restriction]. 3 Permit No. List [ Exit ] 6 3 Press the OK key. 4 Press the U or V key to select reception restriction. To not use the reception restriction, select [Off]. To restrict the other parties only to the ones registered in Permit FAX No. and Permit ID No. as well as the ones registered in the Address Book, select [Permit+Addr Book]. To block incoming faxes from senders registered in Reject FAX No., select [Reject List]. 5 Press the OK key. Unknown Number Reception Select whether to receive the fax of that the number is unknown when [Reject List] is set for Reception Restriction. To change the reception restriction for the unknown fax number, follow the steps below. 1 Refer to Basic Operation Procedure on page 6-7. TX/RX Restrict.: a b 4 Permit ID List 5 Reject No. List *6**U*n*k*n*o*w*n*N*u*m*b*e*r**R*X*** [ Exit ] 2 Press the U or V key to select [UnknownNumber RX]. 3 Press the OK key. 6-37