Kyocera KM-3035 Printer Accounting Systems Settings Guide - Page 16

2-3 Entering Settings through the PRESCRIBE Commands This section describes how to set up the accounting system using the PRESCRIBE commands. The PRESCRIBE commands can be used to enter more detailed settings than those entered through the printer operator panel. During programming which includes accounting functions, the ACNT "ADMN" command is used in the program to declare the start of accounting settings and the ACNT "EDAD" command is used to declare the end. Accounting parameter contents are set between the ACNT "ADMN" and ACNT "EDAD" commands. The four-character parameter (ADMN, etc.) following the ACNT command must be entered as upper case letters. The quotation marks surrounding this parameter may be either double or single quotation marks, but the same type must be used at both sides of the parameter. Accounting Function Operation Commands ADMN-accounting Administrator mode Function The command enables each setting/reference. Command/Parameter Command Parameter ACNT "ADMN", #1; #1 000000000000000 to 999999999999999 (Default value: Depends on model (numeric string consisting of numeric portion of model name followed by zeros) Example for FS6020: 602000000000000) Accounting function administration ID (15-digit numeric string) Note: The parameter setting range for some copiers is 0000 to 9999 (4-digit numeric string). Example of Use The following changes the Accounting function administration ID from "123456789012345" to "678901234561234": !R! ACNT "ADMN", "123456789012345"; ACNT "ADMN", "678901234561234"; ACNT "EDAD";EXIT; Description • By specifying the Accounting function administration ID currently set in a parameter, Accounting function settings can be made between the ACNT "ADMN"; and ACNT "EDAD"; commands. • To change the administration ID, issue the ACNT "ADMN"; command again between the ACNT "ADMN"; and ACNT "EDAD"; commands. 16