Kyocera TASKalfa 7550ci 6550ci/7550ci Operation Guide Rev-1.2011.5 - Page 98

Preparation before Use Loading Originals in the Document Processor The document processor automatically scans each sheet of multiple originals. Both sides of two-sided originals are scanned. Part Names of the Document Processor (1) (2) (3) (4) (5) (6) (1) Original placement indicator (2) Top cover (3) Original width guides (4) Original table (5) Original eject table (6) Original stopper (7) Opening handle (7) Originals Supported by the Document Processor The document processor supports the following types of originals. Weight Size Capacity Document Processor 35 to 220 g/m2 (duplex: 50 to 220 g/m2) Maximum A3 to Minimum A5 Maximum Ledger to Minimum Statement-R Plain paper (80 g/m2), Colored paper, Recycled paper, High Quality: 270 sheets (Mixed size originals: 30 sheets) Thick paper (157 g/m2): 89 sheets Thick paper (120 g/m2): 116 sheets Art paper: 1 sheet Originals Not Supported by the Document Processor Do not use the document processor for the following types of originals. • Soft originals such as vinyl sheets • Transparencies such as OHP film • Carbon paper • Originals with very slippery surfaces • Originals with adhesive tape or glue • Wet originals • Originals with correction fluid which is not dried • Irregularly shaped (non-rectangular) originals • Originals with cut-out sections • Crumpled paper • Originals with folds (Straighten the folds before loading. Failure to do so may cause the originals to jam). • Originals bound with clips or staples (Remove the clips or staples and straighten curls, wrinkles or creases before loading. Failure to do so may cause the originals to jam). 2-48