LG 32LG3DCH Setup Guide - Page 16

Express Script Installer Menu Wizard (LG3DDH TVs only) The Express Script Installer Menu Wizard enables users to set up essential items for viewing the TV the first time it is turned On. The Express Script Installer Menu Wizard can also be activated from the Installer Menu-set Installer Menu item 117 FACT DEFAULT to 001 to reinitiate the Express Script (see the "Installer Menu" section of this document for further information). Note: If you plan to perform the Commercial Mode Setup using the procedure on pages 14 to 15, via cloning, or via the FTG (Free-To-Guest) Configuration Application, be sure to exit the Express Script in order to avoid setup conflicts that may cause the TV to malfunction. Installer Menu Wizard Select Menu Mode Which menu mode will you be using? Express Script Exit Express Script PTC: V1.00.004 CPU: V03.19.00 FPGA: 20E7 OK ► ► Installer Menu Wizard 1► 2► 3► 4► 5► 6► 7 Step 1. Tuning Band Which tuning band would you like to use? F ExitCSacbrilpetStandaGrd ► Back PTC: V1.00.004 CPU: V03.19.00 FPGA: 20E7 Next OK Exit Express Script Installer Menu Wizard 1►2 ► 3► 4► 5► 6► 7 Step 2. Aux Input Which inputs will you be using? Customize Inputs. Use default values. Back Next PTC: V1.00.004 CPU: V03.19.00 FPGA: 20E7 OK Exit Express Script Installer Menu Wizard 1► 2►3► 4►5►6►7 Step 3. Pillow Speaker UWph/iDchobrwannd /pLilleowfts/pReaikgerhctodaerwrioll ywou kbeeuysisng? F Exit SZcreinpitth codeG ► Back PTC: V1.00.004 CPU: V03.19.00 FPGA: 20E7 Next OK Exit Express Script 1. Upon launching, the Installer Menu Wizard prompts you to select a preferred Menu Mode. Use the Up/Down arrow keys on the Installer Remote to select/highlight Express Script in order to proceed with the Installer Menu Wizard. Then, press OK (Enter) on the Installer Remote. The remaining steps of this procedure describe the Express Script Installer Menu Wizard. Use the Installer Remote to make selections and complete each step. You can select the Back button, where available, to check previous settings, as necessary. Note: Select Exit Express Script and press OK (Enter) if you wish to exit the Installer Menu Wizard. 2. Use the Left/Right arrow keys to select the appropriate tuning band (Cable Standard [default], Cable HRC, Cable IRC, or Air). When you have made your selection, use the arrow keys to select Next, and then press OK (Enter). 3. Use the Up/Down arrow keys to select the desired Aux input option. (Note: If you simply select Next and press OK (Enter) in this step, default values will be used.) • To customize settings, select Customize Inputs and press OK (Enter). Aux input options are displayed in a pop-up window. Use the arrow keys to select the input(s) you want to enable or disable. When you are finished, press MENU to close the pop-up window. Then, continue with step 4. • To use default values, select Use default values and press OK (Enter). Then, continue with step 4. 4. If using a Zenith pillow speaker code (default), you can simply select Next and press OK (Enter). Otherwise, select the pillow speaker code field, and use the Left/Right arrow keys to select the appropriate option. When you have made your selection, use the arrow keys to select Next, and then press OK (Enter). (Continued on next page) 16 206-4096