LG BD270 Owner's Manual (English) - Page 22

BD350-N_AUSALLK_MFL62745201 8/20/09 5:19 PM Page 22 Notes: • When [HDMI] option is set to [PCM Multi-Ch], the audio may output as PCM Stereo if the PCM Multi-Ch information is not detected from HDMI device with EDID. • If the [HDMI] or [SPDIF] option is set to [DTS re-encode], the DTS Reencode audio is outputted for BD-ROM discs with secondary audio and the original audio is outputted for the other discs (like [Primary PassThru]). Sampling Freq. [48KHz] - Select this if your A/V Receiver or Amplifier is NOT capable of handling 192 KHz and 96 KHz signal. When this choice is made, this unit automatically converts any 192 KHz and 96 KHz signals to 48 KHz so your system can decode them. [96KHz] - Select this if your A/V Receiver or Amplifier is NOT capable of handling 192 KHz signals. When this choice is made, this unit automatically converts any 192 KHz signals to 96 KHz so your system can decode them. [192KHz] - Select this if your A/V Receiver or Amplifier is capable of handling 192 KHz signals. Check the documentation for your A/V Receiver or Amplifier to verify its capabilities. DRC (Dynamic Range Control) When a disc encoded in Dolby Digital or Dolby Digital Plus is playing back, you may wish to compress the dynamic range of the audio output (the difference between the loudest sounds and the quietest ones). This allows you to listen to a movie at a lower volume without losing clarity of sound. Set DRC to [On] for this effect. Note: The DRC setting can be changed only when a disc is not inserted or the unit is in complete stop mode. [LOCK] Menu (Parental Control) The [LOCK] settings affect only BD and DVD playback. To access the any features in [LOCK] settings, you must enter the 4-digit security code you have created. If you have not entered a password yet, you are prompted to do so. Enter a 4-digit password and press ENTER. Enter it again and press ENTER to verify. Password You can create, change or delete the password. [New] - Enter a 4-digit password and press ENTER. Enter it again and press ENTER to create a new password. [Change] - Enter the current password and press ENTER. Enter a 4-digit password and press ENTER. Enter it again and press ENTER to create a new password. [Delete] - Enter the 4-digit password and press ENTER to delete the password. Tip: If you make a mistake before pressing ENTER, press CLEAR. Then input the correct password. If you forget your password If you forget your password, you can clear it using the following steps: 1. Remove any disc that might be in the player. 2. Select [Password] option in the [Setup] menu. 3. Use Number buttons to enter "210499". The password is cleared. 22