LG H20J55DT Owner's Manual - Page 47

Installer Menu Detailed Descriptions for Installer Menu Items 10-I through 27-I Change values with ADJ (Adjust) Left/Right keys. It may be best to set the same value on every TV. Note: The maximum volume level cannot have a value setting lower than the MIN VOLUME level (See Item 8 -I). 10-I. MUTE DISABLE Enables or disables sound mute function. If set to 1, sound cannot be muted. If set to 0, sound can be muted. 11-I. NOT USED 12-I. IR BANKS EN (IR Banks Enable) For direct access to a particular Channel Bank. When enabled, installer can access a channel bank by inputting the IR code for the bank. 13-I. SCAN MODE Allows variation in the On/Off setup with CHANNEL Up/Down. You may opt for TV channels only or TV channels + Off/On with the following settings for Scan Mode. Scan mode Characteristics: 0 = Channel Up/Down keys Change channels only. 1 = Channel Down below the lowest channel (or channel up higher than the highest channel) and the TV turns Off. 14-I. STRT CH IN SM (Start Channel in Scan Mode) If set to 1, installs TV On/Off event below the start channel at TV turn On. 15-I. SLEEP TIMER If set to 1, the Sleep Timer feature is available (but no message is displayed prior to turn-Off). If set to 0, the Sleep Timer is not functional. 16-I. EN. TIMER (Enable Timer) If set to 1, On/Off Timer functions are available to end user. Set to 0 to disable Timer functions. Note: Clock must be set in order to use Timers. 17-I. ALARM Gives you the option of making the Alarm function available to the user. Set to 1, Alarm function is available to user. Set to 0 to disable the Alarm function. Note: Clock must be set in order to set the Alarm. 18-I. NOT USED 19-I. NOT USED 20-I. FEATURE LEVEL Default set to ZEN 1 for Zenith IR remote control operation. Set O, P LBL for Zenith Private Label IR remote control operation. WARNING: Do not change the default value unless you have the proper remote control to operate the TV. 21-I. V-CHIP Set to 1 to activate V-Chip (Parental Control); have it available to user to filter or control or restrict programming content. Set to 0 to turn V-Chip feature Off, not available to user; no programming restrictions can be set. 22-I. MAX BLK HRS (Maximum Block Hours) Set 0 to 99 for the maximum V-Chip (Parental Control) block hours. Default setup is for 12 blocking hours. 23-I. CAPTION LOCK Set to 1 to restore previous Caption On/Off state after TV turns Off. If set to 0, Captions are always Off, when TV is initially turned On. 24-I. TEXT MODE Determines whether TEXT 1, TEXT 2, TEXT 3, or TEXT 4 decoding is enabled when TEXT is turned on (either from the Setup Menu or directly with CC on the remote). TIP: Set Text Mode to 1 only if text is offered in your video system. 25-I. NOT USED 26-I. NOT USED 27-I. HOSPITAL MODE The default is 2 (which favors most hospitals). With this setting two things are affected: Channel Banks 1, 2 and 3 are accessible, while Bank 4 is inactive. Hosp. Mode=0 Not hospital mode. IR code depends on Item 20-I setting. "Inactive TV" features not available. Hosp. Mode= 1 Zenith P.L. IR Code (Bed 1) Hosp. Mode= 2 Zenith IR Code (Bed 2) 206-4065 Page 47