LG H20J55DT Owner's Manual - Page 8
Hook Up an Off Air Antenna
View all LG H20J55DT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Hook Up an Off Air Antenna Connect an over the air signal source to the TV Over-the-Air Antenna 1 Locate the Antenna/Cable jack on the back of the TV. 2 Connect the RF antenna wire that run from the wall directly to the jack, according to the connection diagram shown to the right. If you have a 75 ohm RF cable, then you donÌt need any adapters! A 300 to 75 ohm adapter is not included with the Zenith TV. Typical TV Back Antenna RF Coaxial Wire (75 ohm) Antenna Cable TV SPEAKER M.P.I. VIDEO IN SPEAKER OUT PILLOW SPEAKER AUDIO IN Mini Glossary 75 ohm RF Cable 300 to 75 ohm Adapter Page 8 The wire that comes from an off-air antenna or cable service provider. Each end looks like a hex shaped nut with a wire sticking through the middle, and it screws onto the threaded jack on the back of the TV. (Not shown) A small device that connects a flat two-wire 300 ohm antenna to a 75 ohm RF jack. They are usually about an inch long with two screws on one end and a round opening with a wire sticking out on the other end. 206-4065