LG LSEL6331F Owners Manual - Page 15
Leveling, Leveling the Range, Checking Adjustments, Connecting Electricity, Electrical Requirements
View all LG LSEL6331F manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
ENGLISH INSTALLATION 15 a 30" (76.2 cm) minimum clearance between the top of the cooking surface and the bottom of an unprotected wood or metal cabinet; or 24" (60.9 cm) minimum when bottom of wood or metal cabinet is protected by not less than 1/4" (6.4 cm) flame retardant millboard covered with not less than no. 28 MSG sheet steel, 0.015" (0.381 mm) stainless steel, 0.024" (0.610 mm) aluminum or 0.020" (0.508 mm) copper. b 15" (38.1 cm) minimum between countertop and adjacent cabinet bottom. NOTE • Important - Save for the use of the local electrical inspector. • For installation in Canada, a free-standing range is not to be installed closer than 15/32" (12 mm) from any adjacent surface. Leveling Leveling the Range Level the range by adjusting the leveling legs with a wrench. Extending the legs slightly may also make it easier to insert the rear leg into the anti-tip bracket. Checking Adjustments 1 Place the level diagonally on the oven rack, and check each direction for level. • First check direction a. Then check direction b. 2 If the level doesn't show that the rack is level, adjust the leveling legs with a wrench. Connecting Electricity Electrical Requirements This appliance must be installed and grounded on a branch circuit by a qualified technician in accordance with the National Electrical code ANSI/ NFPA NO. 70 - latest edition. All wiring should conform to Local and NEC codes. This range requires a single-phase, 3 wire, A.C 120/ 208 V or 120/240 V 60 Hz electrical system. Use only a 3-conductor or a 4-conductor UL - listed range cord with closed-loop terminals, open-end spade lugs with upturned ends or similar termination. Do not install the power cord without a strain relief. A range cord rated at 40 amps with 120/240 minimum volt range is required. If a 50 amp range cord is used, it should be marked for use with 13/ 8" diameter connection openings. This appliance may be connected by means of a conduit or power cord. If a conduit is being used, refer to "3-Wire Connection: Conduit" or "4-Wire Connection: Conduit" sections. WARNING • Allow 2 to 3 ft (61.0 cm to 91.4 cm) of slack in the line so that the range can be moved if servicing is ever necessary. • The power supply cord and plug should not be modified. If it will not fit the outlet, have a proper outlet installed by a qualified electrician. • Using an extension cord to connect the power is prohibited. Connect the power cord and plug directly. • Electrical ground is required on this appliance. • Make sure that the power cord is not pinched by the range or heavy objects. Failure to do so can result in serious burns or electrical shock.