LG LSEL6331F Owners Manual - Page 57
Self Clean, Before Starting Self Clean
View all LG LSEL6331F manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 57 highlights
ENGLISH CAUTION • Some surfaces may be hot after the EasyClean cycle. Wear rubber gloves while cleaning to prevent burns. • During the EasyClean cycle, the oven becomes hot enough to cause burns. Wait until the cycle is over before wiping the inside surface of the oven. Failure to do so may result in burns. • Avoid leaning or resting on the oven door glass while cleaning the oven cavity. 7 A tone will sound at the end of the 10 minute cycle. • Turn the oven mode knob to the OFF position or press CLEAR/OFF to clear the display and end the tone. 8 After the cleaning cycle and during handcleaning, enough water should remain on the oven bottom to completely submerge all soils. Add water if necessary. Place a towel on the floor in front of the oven to capture any water that may spill out during hand-cleaning. 9 Clean the oven cavity immediately after the EasyClean cycle by scrubbing with a wet, nonscratch scouring sponge or pad. (The scouring side will not scratch the finish.) Some water may spill into the bottom vents while cleaning, but it will be captured in a pan under the oven cavity and will not hurt the burner. MAINTENANCE 57 11 If some light soils remain, repeat the above steps, making sure to thoroughly soak the soiled areas. • For models with Self Clean function - If stubborn soils remain after multiple EasyClean cycles, run the Self Clean cycle. Be sure that the oven cavity is empty of oven racks and other accessories, and that the oven cavity surface is dry before running the Self Clean cycle. Consult the Self Clean section of your owner's manual for further details. If a Self Clean option is not available, scrape off and remove stubborn soil using a scraper. NOTE • If you forget to saturate the inside of the oven with water before starting EasyClean, turn the oven mode knob to the OFF position or press CLEAR/OFF to end the cycle. Wait for the range to cool to room temperature and then spray or pour water into the oven and start another EasyClean cycle. • The cavity gasket may be wet when the EasyClean cycle finishes. This is normal. Do not clean the gasket. • If mineral deposits remain on the oven bottom after cleaning, use a cloth or sponge soaked in vinegar to remove them. • It is normal for the fan to operate during the EasyClean cycle. • Using commercial oven cleaners or bleach to clean the oven is not recommended. Instead, use a mild liquid cleanser with a pH value below 12.7 to avoid discoloring the enamel. NOTE • Do not use any steel scouring pads, abrasive pads or cleaners as these materials can permanently damage the oven surface. 10 Once the oven cavity is cleaned, wipe any excess water with a clean dry towel. Replace racks and any other accessories. Self Clean This feature is only available on some models. The Self Clean cycle uses extremely hot temperatures to clean the oven cavity. While running the Self Clean cycle, you may notice smoking or an odor. This is normal; especially if the oven is heavily soiled. During Self Clean, the kitchen should be well ventilated to minimize the odors from cleaning. Before Starting Self Clean • Clean only parts listed in manual. Remove the oven racks, broiler pan, broiler grid, all