Lenovo ThinkCentre A58e English (User guide) - Page 24

bracket properly and aligning the pins on the bracket with the corresponding, by flexing

Get Lenovo ThinkCentre A58e PDF manuals and user guides View all Lenovo ThinkCentre A58e manuals
Add to My Manuals
Save this manual to your list of manuals

Page 24 highlights

3. Place your finger on the tab located on the front of the hard disk drive and push upward. Meanwhile, press inward on the side tabs of the bracket and pivot the hard disk drive upward to remove it from the hard disk drive bay. Figure 10. Removing the hard disk drive 4. Disconnect the signal cable and the power cable from the rear of the old hard disk drive to completely remove it from the computer. 5. Flex the sides of the plastic bracket properly so that the hard disk drive can be removed out of the bracket. 6. Install the new hard disk drive into the plastic bracket 1 by flexing the bracket properly and aligning the pins on the bracket with the corresponding holes on the hard disk drive. Do not touch the circuit board 2 on the bottom of the hard disk drive. Figure 11. Installing the hard disk drive into the bracket 7. Connect the signal cable and the power cable to the rear of the new hard disk drive. 16 User Guide

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
3.
Place your finger on the tab located on the front of the hard disk drive and
push upward. Meanwhile, press inward on the side tabs of the bracket and
pivot the hard disk drive upward to remove it from the hard disk drive bay.
4.
Disconnect the signal cable and the power cable from the rear of the old hard
disk drive to completely remove it from the computer.
5.
Flex the sides of the plastic bracket properly so that the hard disk drive can be
removed out of the bracket.
6.
Install the new hard disk drive into the plastic bracket
±1²
by flexing the
bracket properly and aligning the pins on the bracket with the corresponding
holes on the hard disk drive. Do not touch the circuit board
±2²
on the bottom
of the hard disk drive.
7.
Connect the signal cable and the power cable to the rear of the new hard disk
drive.
Figure 10. Removing the hard disk drive
Figure 11. Installing the hard disk drive into the bracket
16
User Guide