Lexmark 21Z0294 User Guide - Page 85
Menu item, Description, Standby Mode, Notes, Alarms, Timeouts
UPC - 734646313247
View all Lexmark 21Z0294 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 85 highlights
Understanding printer menus Menu item Standby Mode Disabled 1-240 Alarms Alarm Control Toner Alarm Staple Alarm Hole Punch Alarm Timeouts Screen Timeout 15-300 Timeouts Print Timeout Disabled 1-255 Timeouts Wait Timeout Disabled 15-65535 85 Description Sets the amount of time in minutes the printer waits-in a ready‑to‑print state, after a job is printed-before passing into Power Saver mode Notes: • Disabled is the factory default setting. • This setting must be less than or equal to the Power Saver mode setting. Sets an alarm to sound when the printer requires operator intervention Available selections for each alarm type are: Off Single Continuous Notes: • Single is the factory default setting for Alarm Control. Single sounds three quick beeps. • Off is the factory default setting for Toner Alarm, Staple Alarm, and Hole Punch Alarm. Off means no alarm will sound. • Continuous repeats three beeps every 10 seconds. • Stapler Alarm and Hole Punch Alarm are available only when the finisher is installed. Sets the amount of time in seconds the printer waits before returning the printer display to a Ready state Note: 30 seconds is the factory default setting. Sets the amount of time in seconds the printer waits to receive an end‑of‑job message before canceling the remainder of the print job Notes: • 90 seconds is the factory default setting. • When the timer expires, any partially printed page still in the printer is printed, and then the printer checks to see if any new print jobs are waiting. • Print Timeout is available only when using PCL or PPDS emulation. This setting has no effect on PostScript emulation print jobs. Sets the amount of time in seconds the printer waits for additional data before canceling a print job Notes: • 40 seconds is the factory default setting. • Wait Timeout is available only when the printer is using PostScript emulation. This setting has no effect on PCL or PPDS emulation print jobs.