Lexmark CS417 User Guide - Page 151
Printer had to restart. Last job may be incomplete.
View all Lexmark CS417 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 151 highlights
Troubleshooting 151 All life indicators are designed to function with Lexmark supplies and parts, and may deliver unpredictable results if third-party supplies or parts are used. Imaging component usage beyond the intended life may damage your Lexmark printer or its associated components. Warning-Potential Damage: Use of third-party supplies or parts can affect warranty coverage. Damage caused by the use of third-party supplies or parts may not be covered by the warranty. To accept any and all of these risks, and to proceed with the use of non-genuine supplies or parts in your printer, press and continue printing. on the control panel simultaneously for 15 seconds to clear the message and If you do not want to accept these risks, then remove the third-party supply or part from your printer and install a genuine Lexmark supply or part. Note: For the list of supported supplies, see the "Ordering supplies" section or go to www.lexmark.com. Printer had to restart. Last job may be incomplete. From the printer control panel, press to clear the message and continue printing. For more information, go to http://support.lexmark.com or contact customer support. Reinstall missing or unresponsive [color] cartridge [31.xy] Try one or more of the following: • Install the missing toner cartridge. For more information, see the "Replacing supplies" section of the User's Guide. • Remove the unresponsive cartridge, and then reinstall it. Note: If the message appears after reinstalling the supply, then the cartridge may be defective. Replace the cartridge. Reinstall missing or unresponsive black and color imaging kit and all cartridges [31.xy] Try one or more of the following: • Check if the imaging kit is missing. If missing, then install the imaging kit. For information on installing the imaging kit, see the "Replacing supplies" section. • If the imaging kit is installed, then remove and reinstall the unresponsive imaging kit. Note: If the message appears after reinstalling the supply, then replace the imaging kit. The imaging kit may be defective or a non‑genuine Lexmark supply. For more information, see "Using genuine Lexmark parts and supplies" on page 109.