Lexmark T650 Service Manual - Page 175

4062 Sensor (duplex input) late jam service check. Use this procedure for the following jams: • 230.02 • 231.00 Step Check 1 Check the door assembly, rear. Is the above component properly closed? 2 Check the fuser access door. Is the above component properly closed? 3 Check media origination. Did the media originate from the internal duplex? 4 Check the internal duplex media path for obstructions. Is the above component free from obstructions? 5 Check the redrive assembly for damage. Is the above component free from damage? Yes Go to step 2. Go to step 3. Go to step 4 Go to step 5 Go to step 6 6 Perform a print test and check the redrive motor assembly Go to step 7. for proper operation. Does the above component operate properly? 7 Perform a print test and check the duplex drive motor assembly for proper operation. Does the above component operate properly? Go to step 8 8 Check the sensor (duplex input) for proper operation. Go to step 10. 1. Enter the diagnostic mode 2. Select Duplex tests 3. Select sensor test 4. Observe the line item "input" Does the display on the operator panel, change every time the sensing area of the above sensor is interrupted or blocked. No Open then properly close the door assembly, rear. Open then properly close the fuser access door. Go to step 10 Remove obstructions. Replace the redrive assembly. Go to "Option removals" on page 4-83. Replace the redrive motor assembly. Go to "Redrive assembly removal (T650, T652, T654)" on page 4-62. Replace the duplex drive motor assembly. Go to "Duplex drive motor assembly removal (T652, T654)" on page 4-19. Go to step 9. Diagnostic information 2-141