Lexmark T650 Service Manual - Page 51

4062 Error code or message 200.19 Error contents Sensor (input) lingering jam Source = Tray 1 Tray level = Empty 200.27 Sensor (input) lingering jam Source = Tray 2 Tray level = Not Low 200.28 Sensor (input) lingering jam Source = Tray 2 Tray level = Low 200.29 Sensor (input) lingering jam Source = Tray 2 Tray level = Empty 200.32 Operator panel door assembly switch failure 200.33 Sensor (input) early jam 200.34 Sensor (toner empty) failure 200.37 Sensor (input) lingering jam Source = Tray 3 Tray level= Not Low Description/Action Possible repair actions The media reached the sensor (input) but did not clear it within the specified time. The media reached the sensor (input) but did not clear it within the specified time. The media reached the sensor (input) but did not clear it within the specified time. The media reached the sensor (input) but did not clear it within the specified time. Operator panel door assembly not fully closed. Interlock switch not functioning correctly. The media reached the sensor (input) sooner than the specified time. Wrong config ID causes engine to assume 500 paper path on 250 model. The sensor (toner empty) has failed or is not sensing the pulse wheel on the print cartridge. The media reached the sensor (input) but did not clear it within the specified time. Go to sensor (input) lingering jam service check. See "Sensor (input) lingering jam service check." on page 2-132. Go to sensor (input) lingering jam service check. See "Sensor (input) lingering jam service check." on page 2-132. Go to sensor (input) lingering jam service check. See "Sensor (input) lingering jam service check." on page 2-132. Go to sensor (input) lingering jam service check. See "Sensor (input) lingering jam service check." on page 2-132. 1. Ensure that the operator panel door assembly is fully closed. 2. Check operator panel door assembly for damage. 3. Check interlock switch (in left operator panel hinge) for damage. 4. Check all connections on the system card assembly. 1. Fan the media and ensure it is properly installed. 2. Go to sensor (input) early jam service check. See "Sensor (input) early jam service check" on page 2-133. 1. Inspect print cartridge pulse wheel for damage and replace if needed. 2. Check the sensor (toner empty) for proper operation. See "Sensor (toner empty) service check" on page 2-155. Go to sensor (input) lingering jam service check. See "Sensor (input) lingering jam service check." on page 2-132. Diagnostic information 2-17