Lexmark X642E Menus and Messages - Page 97
Attendance messages, Use current [src], Continue, Cancel Job, Scan from Automatic Document Feeder - firmware
UPC - 734646258746
View all Lexmark X642E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 97 highlights
Attendance messages Message Change [src] to [size] [type] Check duplex connection Check tray [x] connection Clean scanner backing strip Meaning Action Lets the user override the current print media source for the remainder of the print job. The formatted page prints as is on the print media installed in the tray. This may cause clipping of text or images. Touch Use current [src] to ignore the message and print on the print media loaded in the tray. Touch Continue: • which continues the job if the correct size and type are loaded in the tray, and this size and type are specified in the Paper Menu using the LCD. • which is ignored if there is no print media in the tray. Touch Cancel Job to cancel the current job if needed. All trays installed under the duplex unit are unavailable if communication is lost, which only leaves Tray 1. If the duplex unit is removed and all trays are reattached, then all the trays are available. The message clears once communication is reestablished. Touch Continue to reconfigure the MFP. It resumes printing without the duplex unit and assumes the unit is unplugged or has lost communication. Tray [x] is not fully connected to the MFP or it has a hardware failure. x represents the number of the tray. The message clears once communication is re-established. If the cause is a hardware failure, turn the MFP off, wait 10 seconds, and then turn the MFP on. If the error recurs, turn the MFP off and remove the offending tray. Touch Continue to reconfigure the MFP to not have tray [x]. Tray [x] and all trays installed below it are ignored. During a scanner calibration, the firmware detects that the scanner backing strip for the backside of scan jobs may be dirty. Touch Cancel Job if a scan job is processing when the attendance message appears. This cancels the job and clears the message. Touch Scan from Automatic Document Feeder if the page jam recovery is active. Scanning resumes from the ADF immediately after the last successfully scanned page. Touch Scan from flatbed if page jam recovery is active. Scanning resumes from the flatbed immediately after the last successfully scanned page. Touch Finish job without further scanning if page jam recovery is active. The job ends at the last successfully scanned page, but the job is not canceled. Successfully scanned pages go to their destination: copy, fax, e-mail, or FTP. Touch Restart job if job recovery is active and the job is restartable. The message clears. A new scan job containing the same parameters as the previous job starts. 97