LiftMaster CSW24VDC CSW24VDC Installation Manual - Page 52

To protect against fire and electrocution: • DISCONNECT power and battery BEFORE installing or servicing operator. Field Wiring Edge N.O. COM N.C. N.O. COM N.C. LOCK Solenoid Lock (Optional) (not provided) LOCK Maglock (Optional) (not provided) Two 12V Solar Panels in Series + -+ - Accessory Power Outlets Antenna Coaxial Antenna Cable CONTROL BOARD + + + N.C Edge Photoelectric Sensors Photoelectric Sensors COM LINK BA AC & BATT FAIL BACKDRIVE Shielded Twisted Pair Cable Primary/Secondary link to other gate operator Ground the shield of the cable to the chassis ground of each operator. Yellow Blue Black Red WIRING DIAGRAM 51 For continued protection against fire: • Replace ONLY with fuse of same type and rating. Field Wiring Input Power Connection L L N Heater GND N GND Red Black White White Purple Black Red Red Black Red 12V 7AH Battery 12V 7AH Battery Black Product ID Piezo Alarm Black White Black Red Butt Splice Switch/5A Breaker Black Red Blocking Diode To Pin 2 To Pin 1 Gray Blue Brown Purple Orange -+ -- Bridge Rectifier Orange Run Stop/Reset Reset Switch Ferrite EMI Filters APS Encoder 1/2 HP 24 Vdc Motor Transformer 375 VA, 24V, 120V EXPANSION BOARD Loop POWER Detector TO MAIN BOARD EMI FILTER/SURGE PROTECTION BOARD NOTE: The accessory outlet is disabled and cannot be used with the 240 Vac option. OPEN CLOSE 1 EYE ONLY 2 EYE/ EDGE 3 EYE/ EDGE COM SBC OPN CLS STP COM SHADOW INTERUPT EXIT Wire Loop Wire Loop Wire Loop Field Wiring Field Wiring EYE EDGE OR EYE EDGE OR EYE N.C.