LiftMaster CSW24VDC CSW24VDC Installation Manual - Page 55

ACCESSORIES ENTRAPMENT PROTECTION DEVICES PHOTOELECTRIC SENSORS (MONITORED, NON-CONTACT) The photoelectric sensors are designed to detect an obstacle in the path of the electronic beam and stop the operator. Includes mounting brackets. Models CPS-UN4 and CPS-RPEN4GM (LiftMaster low power accessory) VEHICLE DETECTION DEVICES PHOTOELECTRIC SENSORS (NON-MONITORED, NON-CONTACT) The photoelectric sensors are designed to detect an obstacle in the path of the electronic beam and stop the operator. Includes mounting brackets. Models AOMRON E3K-R10K4-NR (retro-reflective) and RETROAB 60-2728 (retro-reflective) SENSING EDGE (2-WIRE, NON-MONITORED, CONTACT) Sensing edges can detect an obstacle upon contact and stop the operator. Models 65MG0204, 65MG0205, 65MGR205, and 65MGS205 SENSING EDGE CHANNEL Mounting channel for all MG020 type edges. Model 65ME120C5 REMOTE CONTROLS LiftMaster offers a variety of LiftMaster remote controls to satisfy your application needs. Single-button to 4-button, visor or key chain. The following remote controls are compatible with operators manufactured by LiftMaster after 1993. Contact your authorized LiftMaster dealer for additional details and options. 3-BUTTON REMOTE CONTROL The 3-button remote control can be programmed to control the operator. Includes visor clip. Model 893MAX 3-BUTTON MINI-REMOTE CONTROL The 3-button remote control can be programmed to control the operator. Includes key ring and fastening strip. Model 890MAX KEYLESS ENTRY Enables homeowner to operate gate operator from outside by entering a 4-digit code on a specially designed keypad. Model 877MAX MISCELLANEOUS POST-MOUNTING PLATE For post-mounting model CSW24VDC commercial swing operator (also CSW200 commercial swing operator). Posts not included. Model MPEL REMOTE ANTENNA EXTENSION KIT The remote antenna extension kit allows the antenna to be remotely installed. Model 86LM WIRELESS ACCESS CONTROL RECEIVER Access control receiver for up to 450 remote controls. Model STAR450-315 PLUG-IN LOOP DETECTOR Conveniently plugs into existing control board. Model LOOPDETLM LOOP DETECTOR Low power loop detectors mounted and wired separately inside control box. LiftMaster low power accessory. Model LD7LP VEHICLE SENSING PROBE The vehicle sensing probe is buried in the ground and can detect a car as it approaches and will then open the gate. Model CP3 SOLAR PANEL KIT - 10 WATT This kit is to replace or add a solar panel to the operator application. Up to six solar panels can be connected to the operator in a series/parallel type configuration. Model SOLPNL10W12V (requires 2 minimum) MAGNETIC GATE LOCK Outdoor magnetic lock, transformer, junction box, mounting plate and hardware. Not for use with Solar Applications. Must be powered separately. Model MG1300 HEATER Keeps operator, gearbox and batteries at suitable temperature when outside temperature is below 0°F (-18°C) for extended periods of time. Model HTR LIFTMASTER® INTERNET GATEWAY Internet enabled accessory which connects to the computer and allows you to monitor and control gate operators and lighting accessories enabled by MyQ® technology. Model 828LM 54