LiftMaster CSW24VDC CSW24VDC Installation Manual - Page 9

Overview Of Typical Installation, Single Gate, Dual Gate

Get LiftMaster CSW24VDC PDF manuals and user guides View all LiftMaster CSW24VDC manuals
Add to My Manuals
Save this manual to your list of manuals

Page 9 highlights

INTRODUCTION OVERVIEW OF TYPICAL INSTALLATION Identify your installation type (refer to the Appendix in the back of the manual for more information). SINGLE GATE Warning Sign Photoelectric Sensors Operator Edge Sensors NOTE: One or more non-contact sensors shall be located where the risk of entrapment or obstruction exists at either the opening or closing direction. Care shall be exercised to reduce the risk of nuisance tripping, such as when a vehicle, trips the sensor while the gate is still moving. Earth Ground Rod Check national and local codes for proper depth DUAL GATE Water Tight Conduit (Not provided) NOTE: Power and control wiring MUST be run in separate conduits. Warning Sign Edge Sensor Warning Sign Edge Sensor Operator Photoelectric Sensors Operator Earth Ground Rod Check national and local codes for proper depth 8 Water Tight Conduit (Not provided) NOTE: Power and control wiring MUST be run in separate conduits.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
8
Water Tight Conduit
(Not provided)
NOTE:
Power and control
wiring MUST be run in
separate conduits.
Operator
Earth Ground Rod
Check national and local
codes for proper depth
Warning Sign
Warning Sign
Photoelectric
Sensors
Edge Sensor
Edge Sensor
Operator
Operator
Water Tight Conduit
(Not provided)
NOTE:
Power and control wiring
MUST be run in separate conduits.
Earth Ground Rod
Check national and local
codes for proper depth
Warning Sign
Photoelectric
Sensors
Edge Sensors
INTRODUCTION
OVERVIEW OF TYPICAL INSTALLATION
SINGLE GATE
DUAL GATE
Identify your installation type (refer to the Appendix in the back of the manual for more information).
NOTE:
One or more non-contact
sensors shall be located where
the risk of entrapment or
obstruction exists at either the
opening or closing direction.
Care shall be exercised to reduce
the risk of nuisance tripping,
such as when a vehicle, trips the
sensor while the gate is still
moving.