Maytag MDB6709AWQ Installation Instructions - Page 13

337/8(8"&0cm) Removed AI!thewayup J 341/4" (87 cm). 2 J 5 341/2'' (87:6 cm) , NOTE: If the minimum cabinet opening height is less than 34" (86.4 cm), the rear wheels can be removed for additional clearance. This will allow the dishwasher to fit into a 337/8" (86 cm) high cabinet opening, but the dishwasher will be more difficult to move. (Measurements are approximate. Wheels and legs are preset at the factory for 341/2" (87.6" cm).) Turn both leveler legs to the same height. Put wheels in the required position determined from "Dishwasher Height Adjustment Chart". (To change wheel position, use a fiat-blade screwdriver to pop out the wheel, then snap into the new position.) Mounting stud Setscrew (i nside door handle standoff) Handle tt I_ Allen wrench .... IMPORTANT: Do not scratch the front panel during this procedure. Remove the door handle and hardware bag containing the setscrews and Allen wrench from the cardboard box. Start setscrews in handle. Place handle on mounting studs with the setscrews facing down. Push the door handle tightly against the door. Insert the short end of the Allen wrench into the setscrews. Tighten the setscrews 1/4turn past snug. 1 JStand dishwasher upright Built-up floors (Kitchen floor height is higher than cabinet opening.) Example: Kitchen floor tile does not extend into cabinet opening. Add shims as needed in the area shown to bring the dishwasher up to 34" (86.4 cm) below the countertop. NOTE: Shims must be securely attached to floor to prohibit movement when the dishwasher is in use. Using two or more people, stand dishwasher upright. NOTE: Do not install kickplate until instructed. 13