Maytag MDB6709AWQ Installation Instructions - Page 14

Cable IMPORTANT: Double check correct placement of utilities. Grasp the sides of the dishwasher at the edges of the door panel. Tilt dishwasher backwards on wheels and move dishwasher close to cabinet opening. NOTE: Do not push on the front of the panel or on the console-they may dent. Helpful Tip: Temporarily tape utilities to the floor in the locations shown to prohibit them from moving when dishwasher is moved into the cabinet opening. If the door closes too quickly, decrease the spring tension by moving the spring end toward the front of the dishwasher. NOTE: Springs should be in the same notches on left and right sides. Check that water line is on the left side of opening and drain hose is near the center of the cabinet o _ening. If the door falls open, increase the spring tension by moving the spring end toward the back of the dishwasher. NOTE: Springs should be in the same notches on left and right sides. With another person holding the dishwasher to avoid it from tipping, open and close the door a few times. If the door closes or falls open under its own weight, the door tension will need to be adjusted. 14 IMPORTANT: If wheels were removed, avoid damage to the floor when moving the dishwasher. Slowly move dishwasher completely into cabinet opening. Do not kink or pinch water line, drain hose, power supply cord or direct wire between dishwasher and cabinet. Remove cardboard from under dishwasher. NOTE: It is all right if dishwasher fits tightly into cabinet opening. Do not remove insulation blanket- the blanket reduces the sound level. NOTE: If using power cord, make sure to route end through hole in cutout before sliding into cabinet opening.