Maytag MGDE300VF Installation Instructions - Page 12

• Do not use an exhaust hood with a magnetic latch. improper venting can cause moisture and lint to collect indoors, which may result in: [] Moisture damage to woodwork, furniture, paint, wallpaper, carpets, etc. [] Housecleaning problems and health problems. Plan Vent System Choose your exhaust installation type Recommended exhaust installations Typical installationsvent the dryer from the rear of the dryer. Other installations are possible. B , C [\ A B A. Standard rear offset exhaust installation B. Left or fight side exhaust installation C. Bottom exhaust installation Alternate installations for close clearances Venting systems come in many varieties. Select the type best for your installation. Two examples of close-clearance installations are shown. Refer to the manufacturer's instructions. A iiii ' iii ,iiL ,j A. Dryer B. Elbow C. Wall D. Exhaust hood E. Clamps E Rigid metal or flexible metal vent G. Vent length necessary to connect elbows H. Exhaust outlet Optional exhaust installations This dryer can be converted to exhaust out the right side, left side, or through the bottom. If you prefer, you may contact your local dealer to have the dryer converted. Fire Hazard Cover unused exhaust holes with one of the following kits: 279818 (white) W10186596 (midnight grey) Contact your local dealer. Failure to follow these instructions can result in death, fire, electrical shock, or serious injury. A B A. Over-the-top installation (also available with one offset elbow) B. Periscope installation NOTE: The following kits for close-clearance alternate installations are available for purchase. Please see the "Assistance or Service" section to order. • Over-the-Top Installation: Part Number 4396028 • Periscope Installation (For use with dryer vent to wall vent mismatch): Part Number 4396037 - 0" (0 mm) to 18" (460 mm) mismatch Part Number 4396011 - 18" (460 mm) to 29"(737 mm) mismatch Part Number 4396014 - 29" (737 mm) to 50" (1270 mm) mismatch Special provisions for mobile home installations The exhaust vent must be securely fastened to a noncombustible portion of the mobile home structure and must not terminate beneath the mobile home. Terminate the exhaust vent outside. 1 Determine vent path • Select the route that will provide the straightest and most direct path outdoors. 12