McAfee IIP-M80K-ISAA Product Guide - Page 13

McAfee® IntruShield® IPS 4.1 M-8000 Sensor Product Guide Overview M-8000 physical description 11 Two Power Supplies-B (optional, purchased separately). Power supply B is a hotswappable, redundant power supply. This power supply also uses a standard IEC320-C13 port, and you can use the McAfee-provided cable or acquire one that meets your specific needs. 12 Two RJ-45 10/100/1000 Interconnect ports, which are used to connect the primary sensor to the secondary sensor. The M-8000 does not have internal taps; it must be used with a third-party external tap to run in tapped mode. Front panel LEDs The front panel LEDs provide status information for the health of the sensor and the activity on its ports. The following table describes the M-8000 front panel LEDs. LED Status Description Pwr A (Power A) Green Amber Power Supply A is functioning. Power Supply A is not functioning. Pwr B (Power B) Green Amber Power Supply B is functioning. Power Supply B is not functioning. Note: If a power supply is not present, both green and amber LEDs are off. Management Port Speed Green Amber Off The port speed is 1000 Mbps. The port speed is 100 Mbps. The port speed is 10 Mbps. Management Port Link Green Off The link is connected. The link is disconnected. Sys Green Sensor is operating. Amber Sensor is booting. (It could also indicate a system failure.) Fan Green All three fans are operating. Amber One or more of the fans has failed. Temp Green Amber Inlet air temperature measured inside chassis is normal. (Chassis temperature OK.) Inlet air temperature measured inside chassis is too hot. (Chassis temperature too hot.) Flash Green Off Activity on external compact flash. (For example, the Fail-Open Controller has been inserted.) No activity on external compact flash. 5