McAfee IIP-M80K-ISAA Product Guide - Page 32

Troubleshooting,

Get McAfee IIP-M80K-ISAA - Network Security Platform M-8000 PDF manuals and user guides View all McAfee IIP-M80K-ISAA manuals
Add to My Manuals
Save this manual to your list of manuals

Page 32 highlights

CHAPTER 5 Troubleshooting This section lists some common installation problems and their solutions. Problem LED is off. Possible Cause The control cable has been disconnected. Solution Check the control cable and ensure it is properly connected to both the sensor and the Bypass Switch. LED is off. The sensor is powered off. Restore sensor power. LED is off. The sensor port cable is disconnected. Check the sensor cable connections. Sensor is Network device cables have operational, but been disconnected. is not monitoring traffic. Check the cables and ensure they are properly connected to both the network devices and the Bypass Switch. Sensor is The sensor ports have not The sensor will not monitor traffic on operational, but been enabled in the Manager. the ports unless the ports are enabled is not in the Manager. Ports are disabled in a monitoring sensor failure; they must be re- traffic. enabled for sensor monitoring to resume. Network or link Improper cabling or port problems. configuration. Ensure that the transmit and receive cables are properly connected to the Bypass Switch. Runts or giants errors on switch and routers. Improper cabling or port configuration. Ensure that the transmit and receive cables are properly connected to the Bypass Switch. The system fault "Switch absent" appears in the Manager System Health window. The control cable has been disconnected. Check the control cable and ensure it is properly connected to both the sensor and the Bypass Switch. 24

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
C
HAPTER
5
Troubleshooting
This section lists some common installation problems and their solutions.
Problem
Possible Cause
Solution
LED is off.
The control cable has been
disconnected.
Check the control cable and ensure it
is properly connected to both the
sensor and the Bypass Switch.
LED is off.
The sensor is powered off.
Restore sensor power.
LED is off.
The sensor port cable is
disconnected.
Check the sensor cable connections.
Sensor is
operational, but
is not
monitoring
traffic.
Network device cables have
been disconnected.
Check the cables and ensure they are
properly connected to both the network
devices and the Bypass Switch.
Sensor is
operational, but
is not
monitoring
traffic.
The sensor ports have not
been enabled in the Manager.
The sensor will not monitor traffic on
the ports unless the ports are enabled
in the Manager. Ports are disabled in a
sensor failure; they must be re-
enabled for sensor monitoring to
resume.
Network or link
problems.
Improper cabling or port
configuration.
Ensure that the transmit and receive
cables are properly connected to the
Bypass Switch.
Runts or giants
errors on
switch and
routers.
Improper cabling or port
configuration.
Ensure that the transmit and receive
cables are properly connected to the
Bypass Switch.
The system
fault “Switch
absent”
appears in the
Manager
System Health
window.
The control cable has been
disconnected.
Check the control cable and ensure it
is properly connected to both the
sensor and the Bypass Switch.
24