McAfee IIP-M80K-ISAA Product Guide - Page 18

Setting up an M-8000, Setup Overview, Positioning the sensor

Get McAfee IIP-M80K-ISAA - Network Security Platform M-8000 PDF manuals and user guides View all McAfee IIP-M80K-ISAA manuals
Add to My Manuals
Save this manual to your list of manuals

Page 18 highlights

CHAPTER 3 Setting up an M-8000 This chapter describes the process of setting up a sensor to prepare it for configuration. Setup Overview Setting up a sensor involves the following steps: 1 Positioning the sensor. (See below.) 2 Installing interface modules (SFP and XFP). 3 Attaching power, network, and monitoring cables. (See Attaching Cables to the M-8000 sensor.) 4 Powering on the sensor. (See Powering on the sensor.) Once you have set up and powered on the sensor, you can proceed with configuration. Positioning the sensor Place the sensor in a physically secure location, close to the switches or routers it will be monitoring. Ideally, the sensor should be located within a standard communications rack. The M-8000 sensor consists of two 2RU units (M-8000 P and M-8000 S). To mount the sensor in a rack, you will attach two mounting ears and rails to the sensor as described below. Installing the rails and ears on the chassis and rack Caution: Before you install the rails and ears on the chassis, make sure that power is OFF. Remove the power cable and all network interface cables from the sensor. Each rack-mounting rail and ear has holes that match up with holes in the chassis. To install the rails and ears on the chassis, follow these steps-using a Phillips screwdriver to secure the Phillips flathead screws: 10

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
C
HAPTER
3
Setting up an M-8000
This chapter describes the process of setting up a sensor to prepare it for
configuration.
Setup Overview
Setting up a sensor involves the following steps:
1
Positioning the sensor. (See below.)
2
Installing interface modules (SFP and XFP).
3
Attaching power, network, and monitoring cables. (See Attaching Cables to the
M-8000 sensor.)
4
Powering on the sensor. (See Powering on the sensor.)
Once you have set up and powered on the sensor, you can proceed with
configuration.
Positioning the sensor
Place the sensor in a physically secure location, close to the switches or routers it will
be monitoring. Ideally, the sensor should be located within a standard
communications rack.
The M-8000 sensor consists of two 2RU units (M-8000 P and M-8000 S).
To mount the sensor in a rack, you will attach two mounting ears
and rails to the
sensor as described below.
Installing the rails and ears on the chassis and rack
Caution:
Before you install the rails and ears on the chassis, make sure that power
is OFF. Remove the power cable and all network interface cables from the sensor.
Each rack-mounting rail and ear has holes that match up with holes in the chassis.
To install the rails and ears on the chassis, follow these steps—using a Phillips
screwdriver to secure the Phillips flathead screws:
10