Netgear GSM7328Sv1 7000 Series Managed Switch Administration Guide for Softwar - Page 301

NETGEAR 7000 Series Managed Switch Administration Guide Version 7.3 Moving a Master to a Different Unit in the Stack This example is provided as CLI commands and a Web interface procedure. CLI: Moving a Master to a Different Unit in the Stack 1. Using the movemanagement command, move the master to the desired unit number. The operation may take between 30 seconds and 3 minutes depending on the stack size and configuration. The command is movemanagement 2. Make sure that you can log in on the console attached to the new master. Use the show switch command to verify that all units rejoined the stack. 3. It is recommended that the stack be reset with the reload command after moving the master. Web Interface: Moving a Master to a Different Unit in the Stack To use the Web interface to move a master to a another unit, proceed as follows: 1. Move a master from unit 1 to unit 2. a. From the main menu, select System > Management > Basic > Stack Configuration. A screen similar to the following displays. Figure 20-5 b. Select the 2 from the Management Unit Selected pull-down menu. c. A warning window is popped up, click the OK button Managing Switch Stacks v1.0, November 2008 20-13