Netgear GSM7328Sv1 7000 Series Managed Switch Administration Guide for Softwar - Page 83

NETGEAR 7000 Series Managed Switch Administration Guide Version 7.3 1. From the main menu, select Routing > Basic >IP Configuration. A screen similar to the following displays. Figure 8-2 2. Next to the Routing Mode, select the Enable radio button. 3. Click Apply to save the settings. Enable Routing for Ports The example is shown as CLI commands and as a Web interface procedure. CLI: Enabling Routing for Ports Enable routing and assigns IP addresses for ports 1/0/2 and 1/0/3. (Netgear Switch) #config (Netgear Switch) (Config)#interface 1/0/2 (Netgear Switch) (Interface 1/0/2)#routing (Netgear Switch) (Interface 1/0/2)#ip address 192.150.2.1 255.255.255.0 (Netgear Switch) (Interface 1/0/2)#exit (Netgear Switch) (Config)#interface 1/0/3 (Netgear Switch) (Interface 1/0/3)#routing (Netgear Switch) (Interface 1/0/3)#ip address 192.150.3.1 255.255.255.0 (Netgear Switch) (Interface 1/0/3)#exit (Netgear Switch) (Config)#exit Web Interface: Enabling Routing for the Ports To use the Web interface to configure the managed switch, proceed as follows: 1. Assign IP address 192.150.2.1/24 to the interface 1/0/2. Routing Information Protocol 8-3 v1.0, November 2008