Netgear GSM7328Sv1 7000 Series Managed Switch Administration Guide for Softwar - Page 82

NETGEAR 7000 Series Managed Switch Administration Guide Version 7.3 The configuration commands used in the following example enable RIP on ports 1/0/2 and 1/0/3 as shown in the network illustrated in Figure 8-1 Layer 3 Switch acting as a router Port 1/0/2 192.150.2.2 Port 1/0/5 192.64.4.1 Port 1/0/3 192.130.3.1 Subnet 2 Figure 8-1 Subnet 3 Subnet 5 Enable Routing for the Switch The example is shown as CLI commands and as a Web interface procedure. CLI: Enabling Routing for the Switch The following sequence enables routing for the switch: (Netgear Switch) #config (Netgear Switch) (Config)#ip routing (Netgear Switch) (Config)#exit Web Configuration: Enabling Routing for the Switch To use the Web interface to configure the managed switch, proceed as follows: 8-2 Routing Information Protocol v1.0, November 2008