Netgear GSM7352Sv1 7000 Series Managed Switch Administration Guide for Softwar - Page 117
Web Interface: Configuring Area 1 as a Stub Area on A2
View all Netgear GSM7352Sv1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 117 highlights
NETGEAR 7000 Series Managed Switch Administration Guide Version 7.3 Enable OSPF area 0.0.0.1 on the 1/0/15. (Netgear Switch) (Config-router)#exit (Netgear Switch) (Config-router)#exit (Netgear Switch) (Config)#interface 1/0/15 (Netgear Switch) (Interface 1/0/15)#routing (Netgear Switch) (Interface 1/0/15)#ip address 192.168.20.2 (Netgear Switch) (Interface 1/0/15)#ip ospf (Netgear Switch) (Interface 1/0/15)#ip ospf areaid 0.0.0.1 255.255.255.0 (Netgear Switch) (Interface 1/0/15)#exit (Netgear Switch) (Config)#exit (Netgear Switch) #show ip route Total Number of Routes 2 Network Subnet Address Mask Protocol 0.0.0.0 0.0.0.0 OSPF Inter 192.168.20.0 255.255.255.0 Local Next Hop Intf --------1/0/15 1/0/15 Next Hop IP Address 192.168.20.1 192.168.20.2 Web Interface: Configuring Area 1 as a Stub Area on A2 To use the Web interface to configure OSPF on the switch, proceed as follows: 1. Enable IP routing on the switch. a. From the main menu, select Routing > IP > IP Configuration. A screen similar to the following displays. Figure 9-24 b. Next to the Routing Mode, select the Enable radio button. c. Click Apply to save the settings. OSPF v1.0, November 2008 9-23