Netgear GSM7352Sv1 7000 Series Managed Switch Administration Guide for Softwar - Page 91
Web Interface: VLAN Routing RIP Configuration, Click the gray box under port 2 once until
View all Netgear GSM7352Sv1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 91 highlights
NETGEAR 7000 Series Managed Switch Administration Guide Version 7.3 Enable RIP for the VLAN router ports. Authentication will default to none, and no default route entry will be created. (Netgear Switch) (Config)#interface vlan 10 (Netgear Switch) (Interface vlan 10)#ip rip (Netgear Switch) (Interface vlan 10)#exit (Netgear Switch) (Config)#interface vlan 20 (Netgear Switch) (Interface vlan 20)#ip rip (Netgear Switch) (Interface vlan 20)#exit (Netgear Switch) (Config)#exit Web Interface: VLAN Routing RIP Configuration To use the Web interface to configure RIP on the switch, proceed as follows: 1. Configure a VLAN and include ports 1/0/2 in the VLAN: a. From the main menu, select Routing > VLAN > VLAN Routing Wizard. A screen similar to the following displays. Figure 8-9 b. Enter the following information in the VLAN Routing Wizard: • In the Vlan ID field, enter 10. • In the IP Address field, enter 192.150.3.1. • In the Network Mask field, enter 255.255.255.0. c. Click Unit 1. The ports display: Click the gray box under port 2 once until T displays. The T specifies that the egress packet is tagged for the port. d. Click Apply to save the VLAN that includes ports 2. 2. Configure a VLAN and include ports 1/0/3 in the VLAN: Routing Information Protocol v1.0, November 2008 8-11