Netgear GSM7352Sv1 7000 Series Managed Switch Administration Guide for Softwar - Page 96
CLI: Configuring an Inter-Area Router, Step 1: Enable Routing for the switch.
View all Netgear GSM7352Sv1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 96 highlights
NETGEAR 7000 Series Managed Switch Administration Guide Version 7.3 The first diagram shows a network segment with an inter-area router connecting areas 0.0.0.2 and 0.0.0.3. The example script shows the commands used to configure a 7000 Series Managed Switch as the inter-area router in the diagram by enabling OSPF on port 1/0/2 in area 0.0.0.2 and port 1/0/3 in area 0.0.0.3. Layer 3 Switch acting as an inter-area router Port 1/0/2 192.150.2.1 Port 1/0/3 192.150.3.1 Border Router Border Router Figure 9-1 Area 2 Area 3 CLI: Configuring an Inter-Area Router Step 1: Enable Routing for the switch. (Netgear Switch) #config (Netgear Switch) (Config)#ip routing (Netgear Switch) (Config)#exit Step 2: Assign IP addresses for ports. (Netgear Switch) #config (Netgear Switch) (Config)#interface 1/0/2 (Netgear Switch) (Interface 1/0/2)#routing (Netgear Switch) (Interface 1/0/2)#ip address 192.150.2.1 255.255.255.0 (Netgear Switch) (Interface 1/0/2)#exit (Netgear Switch) (Config)#interface 1/0/3 (Netgear Switch) (Interface 1/0/3)#routing (Netgear Switch) (Interface 1/0/3)#ip address 192.150.3.1 255.255.255.0 (Netgear Switch) (Interface 1/0/3)#exit (Netgear Switch) (Config)#exit 9-2 v1.0, November 2008 OSPF