Netgear GSM7352Sv1 7000 Series Managed Switch Administration Guide for Softwar - Page 74
CLI: Creating Two VLANs, VLAN Routing
View all Netgear GSM7352Sv1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 74 highlights
NETGEAR 7000 Series Managed Switch Administration Guide Version 7.3 The diagram in this section shows a Layer 3 switch configured for port routing. It connects two VLANs, with two ports participating in one VLAN, and one port in the other. The script shows the commands you would use to configure a 7000 Series Managed Switch to provide the VLAN routing support shown in the diagram. Layer 3 Switch Port 1/0/2 VLAN Router Port 1/3/1 192.150.3.1 Port 1/0/3 VLAN Router Port 1/3/2 192.150.4.1 Port 1/0/1 Layer 2 Switch Layer 2 Switch VLAN 10 VLAN 20 Figure 7-1 CLI: Creating Two VLANs The following code sequence shows an example of creating two VLANs with egress frame tagging enabled. (Netgear Switch) #vlan data (Netgear Switch) (Vlan)#vlan 10 (Netgear Switch) (Vlan)#vlan 20 (Netgear Switch) (Vlan)#exit (Netgear Switch) #conf (Netgear Switch) (Config)#interface range 1/0/1-1/0/2 (Netgear Switch) (conf-if-range-1/0/1-1/0/2)#vlan participation include 10 (Netgear Switch) (conf-if-range-1/0/1-1/0/2)#vlan pvid 10 (Netgear Switch) (conf-if-range-1/0/1-1/0/2)#exit (Netgear Switch) (Config)#interface 1/0/3 (Netgear Switch) (Interface 1/0/3)#vlan participation include 20 (Netgear Switch) (Interface 1/0/3)#vlan pvid 20 (Netgear Switch) (Interface 1/0/3)#exit (Netgear Switch) (Config)#exit 7-2 VLAN Routing v1.0, November 2008