Netgear GSM7352Sv1 7000 Series Managed Switch Administration Guide for Softwar - Page 198
Con Traffic Shaping, CLI: Configuring traffic-shape
View all Netgear GSM7352Sv1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 198 highlights
NETGEAR 7000 Series Managed Switch Administration Guide Version 7.3 2. Under CoS Configuration, Select the Interface radio button. 3. Select 1/0/3 from the interface pull-down menu. 4. Select trust dot1p from the Interface Trust Mode pull-down menu. 5. Click the Apply to save the settings. Configure Traffic Shaping This section describes the Traffic Shaping feature. Traffic shaping controls the amount and volume of traffic transmitted through a network. This has the effect of smoothing temporary traffic bursts over time. Use the traffic-shape command to enable traffic shaping by specifying the maximum transmission bandwidth limit for all interfaces (Global Config) or for a single interface (Interface Config). The value is a percentage that ranges from 0 to 100 in increments of 5. The default bandwidth value is 0, meaning no upper limit is enforced, which allows the interface to transmit up to its maximum line rate. The bw value is independent of any per-queue maximum bandwidth value(s) in effect for the interface and should be considered as a second-level transmission rate control mechanism that regulates the output of the entire interface regardless of which queues originate the outbound traffic. CLI: Configuring traffic-shape (Netgear Switch) (Config)#traffic-shape? Enter the shaping bandwidth percentage from 0 to 100 in increments of 5. (Netgear Switch) (Config)#traffic-shape 70? Press Enter to execute the command. (Netgear Switch) (Config)#traffic-shape 70 (Netgear Switch) (Config)# Web Interface: Configuring Traffic-shape To use the Web interface to configure traffic-shape, proceed as follows: 1. Set the shaping bandwidth percentage to 70%. 13-10 v1.0, November 2008 Class of Service (CoS) Queuing