Olympus E10 E-10 Instructions (English) - Page 84
Press the, button., Take the picture.
View all Olympus E10 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 84 highlights
Bracketing a Shot with Three Automatic Exposures (continued) Control panel 7 Autobracket setting mark Sequential mode Sequential mode selected automatically when autobracketing is selected. 7 Press the button. This completes setting the camera for autobracketing. In the control panel, you will see BKT and the sequential mode mark displayed. This confirms that the camera is set for both autobracketing and shooting multiple exposures. (When shooting in the single-frame mode, hold down the drive button and turn the main dial or sub dial until you do not see the sequential mode mark displayed in the control panel.) Press the button again to close the menu. 8 Take the picture. When the camera is set in the sequential mode, press the shutter button once to shoot three rapid pictures with the exposure setting varied automatically for each shot. When the camera is set in the singleframe shooting mode, you must press the button once to take each picture with the exposure setting varied automatically for each shot. Note • The autobracketing setting is disabled and cannot be used in the following cases: - When the mode dial is set to M (Manual mode) - When the flash button is pressed and the built-in flash is raised. • The mode dial setting determines which features are changed during autobracketing. P Program mode. Shutter speed and aperture value adjusted. A Aperture priority mode. Shutter speed adjusted. S Shutter priority mode. Apeture adjusted. • The shutter speed and aperture value display the adjusted exposure. • If autobracketing (© 81) and exposure compensation (© 79) are selected together, then values are calculated for both during shooting with autobracketing. • If the camera is switched off suddenly during autobracket shooting, the camera will finish the autobracketing shooting sequence after the camera is switched on again. • Autobracketing will halt as soon as you release your finger from the shutter button and resume shooting the remaining pictures after you press the shutter button again. • With the camera set in autobracketing, you cannot select the self-timer mark , or the remote control mark . To select these marks, release the camera from autobracketing with the menu. • If you select autobracketing while the self-timer mode or the remote control mode is set, both modes will be automatically released. 82