Onkyo TX-NR3009 Owner Manual - Page 73

Zone 2 Video Output The AV receiver features a composite video output for connection to a TV in Zone 2, so you can enjoy both audio and video in that zone. Hookup • Use a composite video cable to connect the AV receiver's ZONE 2 OUT V jack to a composite video input on your Zone 2 TV. Controlling Zone 2/3 Components ■ Operating on the AV receiver Input selector buttons MASTER VOLUME Main room TV AV receiver Zone 2 TV Note • The ZONE 2 OUT V jack outputs video from components con- nected to composite video only. 12V Trigger Out When Zone 2/3 is turned on, the output from the 12V TRIGGER OUT jack goes high (+12 V and max. 150 mA for Zone 2, +12 V and max. 25 mA for Zone 3). Connecting this jack to a 12-volt trigger input on a component in Zone 2/3 will make that component turn on or off as the AV receiver turns on or off the Zone 2/3. ZONE 3 ZONE 2 OFF 1 To turn on Zone 2/3 and select an input source, press ZONE 2 or ZONE 3 followed by an input selector button within 8 seconds. Zone 2/3 turns on, the Z2/3 indicator lights on the display. Tip • The corresponding trigger output goes high (+12 V). To select AM or FM, press TUNER input selector and ZONE 2 or ZONE 3 repeatedly. To select the same source as the main room's, press ZONE 2 or ZONE 3 twice. "Z2 Selector: Source" or "Zone 3 Selector: Source" appears on the display. 2 To turn off Zone 2/3, press ZONE 2 or ZONE 3. The Z2/3 indicator on the display flash. Press OFF. The zone is turned off. Tip • The corresponding trigger output goes low (0 volts). ■ Operating on the remote controller To control Zone 2/3, you must press the remote controller's ZONE first. ZONE turns red while Zone 2 is on, and green while Zone 3 is on. RECEIVER ZONE Input selector buttons MUTING VOLR/X 1 Press ZONE repeatedly, then point the remote controller at the AV receiver and press RECEIVER. Zone 2/3 turns on, the Z2/3 indicator lights on the display. Tip En • The corresponding trigger output goes high (+12 V). 73