Onkyo TX-NR3009 Owner Manual - Page 90

■ The following settings can be made for the S-Video and composite video inputs You must use the buttons on the unit to make these settings. On the AV receiver, press the input selector for the input source that you want to set and the SETUP button simultaneously. While holding down the input selector button, press SETUP until "Video ATT:On" appears on the display. Then, release both buttons. To reactivate the setting, repeat the above process so that "Video ATT:Off" appears on the display, and release the buttons. • Video Attenuation This setting can be made for the BD/DVD, VCR/DVR, CBL/SAT, GAME or AUX input. If you have a game console connected to the composite video input, and the picture isn't very clear, you can attenuate the gain. Video ATT:Off: (default). Video ATT:On: Gain is reduced by 2 dB. ■ If the picture on your TV/monitor connected to the HDMI output(s) is unstable, try switching the DeepColor function off To turn off the DeepColor function, simultaneously press the CBL/SAT and ON/STANDBY buttons on the AV receiver. While holding down CBL/SAT, press ON/STANDBY until "Off" appears on the display. Then, release both buttons. To reactivate the DeepColor function, repeat the above process until "On" appears on the display and release the buttons. The AV receiver contains a microcomputer for signal processing and control functions. In very rare situations, severe interference, noise from an external source, or static electricity may cause it to lockup. In the unlikely event that this happens, unplug the power cord from the wall outlet, wait at least five seconds, and then plug it back in. Important Note Regarding Video Playback The AV receiver can upconvert component video, SVideo, and composite video sources for display on a TV connected to the HDMI output(s). However, if the picture quality of the source is poor, upconversion may make the picture worse or disappear altogether. In this case, try the following: 1 If the video source is connected to a component video input, connect your TV to the COMPONENT VIDEO MONITOR OUT. If the video source is connected to an S-Video input, connect your TV to a MONITOR OUT S. If the video source is connected to a composite video input, connect your TV to the MONITOR OUT V. 2 On the main menu, select "Input/Output Assign" and then "Component Video Input" (➔ page 50). If the video source is connected to COMPONENT VIDEO IN 1, select the relevant input selector, and assign it to "IN1". If the video source is connected to COMPONENT VIDEO IN 2, select the relevant input selector, and assign it to "IN2". If the video source is connected to COMPONENT VIDEO IN 3, select the relevant input selector, and assign it to "IN3". If the video source is connected to an S-Video input or composite video input, select the relevant input selector, and assign it to Tip • To by-pass the upconversion, set the "Picture Mode" setting to "Direct" (➔ page 61). Onkyo is not responsible for damages (such as CD rental fees) due to unsuccessful recordings caused by the unit's malfunction. Before you record important data, make sure that the material will be recorded correctly. Before disconnecting the power cord from the wall outlet, set the AV receiver to standby. En 90