Onkyo TX SR804 Instruction Manual - Page 41
Apply the Results, Retry, Retry with Test noise Level up, Cancel, Use the Up and Down
View all Onkyo TX SR804 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 41 highlights
First Time Setup-Continued 3 ENTER 4 ENTER ENTER Press [ENTER]. The automatic speaker setup starts. The test tone is output by each speaker in turn. The microphone picks up the sound and feeds it back to the AV receiver, where it's used to calculate the optimum speaker settings. The whole process takes about 2 minutes. Auto Speaker Setup Do not unplug Setup Mic. Please, keep quiet. Now measuring Left 5 Disconnect the speaker setup microphone. Auto Speaker Setup Please,unplug Setup Mic. Tip: • You can cancel the automatic speaker setup at anytime by disconnecting the microphone. Note: • If any extraneous noise is picked up by the microphone, the automatic setup may not work correctly, so keep quiet. On completion, the following menu appears. Auto Speaker Setup Apply the Results Check the Results Retry Retry with Test noise Level up Cancel Use the Up and Down [ ]/[ ] buttons to select one of the following options, and then press [ENTER]. ☞ Apply the Results: Select this to save the results, then continue with step 5. Normally, you'd select this option. Check the Results: Select this if you want to view the results. See "Checking the Results" on page 42. Retry: Select this if you want to run the automatic speaker setup again, starting from step 3. Retry with Test noise Level up: Select this to run the automatic speaker setup again but with the test tone louder, starting from step 3. Cancel: Select this to cancel the automatic speaker setup without saving the results, then continue with step 5. 41