Onkyo TX SR804 Instruction Manual - Page 84

Zone 2-Continued Controlling Zone 2 with the Remote Controller STANDBY ON INPUT SELECTOR ON STANDBY I T V INPUT V1 V2 V3 1 2 3 + V4 MULTI CH DVD T V CH 4 5 6 - CD TAPE TUNER 7 8 9 PHONO T V VOL +10 0 CLEAR - -/--- 10 11 12 INPUT SELECTOR MACRO 1 2 3 ZONE2 RECEIVER TAPE/AMP REMOTE MODE DVD CD HDD LISTENING MODE STEREO SURR REPEAT AUDIO SUBTITLE PLAY MODE PURE A DIRECT THX ALLST TESTTONE CH SEL OPEN/CLOSE VIDEO OFF LEVEL L NIGHT LEVEL Re-EQ RC-620M ZONE2 LEVEL-, LEVEL+ Note: • To control Zone 2, you must press the remote control- ler's [ZONE 2] REMOTE MODE button first. 1 ZONE2 ON Press the [ZONE 2] REMOTE MODE button, then point the remote controller at the AV receiver and press the [ON] button. Zone 2 turns on, and the ZONE 2 12V TRIGGER OUT goes high (+12 V). 2 ZONE2 To select an input source for Zone 2, press the [ZONE 2] REMOTE MODE button, followed by an INPUT SELECTOR button. To select AM, FM, or XM, press the V1 V2 V3 [TUNER] INPUT SELECTOR button 1 2 3 repeatedly. V4 DVD 4 6 CD 7 PHONO +10 TAPE 8 TUNER 9 3 ZONE2 STANDBY To turn off Zone 2, press the [ZONE 2] REMOTE MODE button, followed by the [STANDBY] button. Adjusting the Volume for Zone 2 ZONE 2 LEVEL , STANDBY/ON POWER STANDBY ZONE 2 ON OFF PURE AUDIO MULTI CH DVD VIDEO 1 VIDEO 2 VIDEO 3 VIDEO 4 TAPE TUNER CD PHONO DISPLAY MASTER VOLUME PHONES ZONE 2 OFF TONE ZONE 2 LEVEL STEREO TUNING DIMMER MEMORY MODE LISTENING MODE CLEAR SETUP RETURN ENTER SETUP MIC PRESET PRESET TUNING DIGITAL VIDEO 4 INPUT S VIDEO VIDEO L AUDIO R 1 ZONE2 LEVEL LEVEL On the remote controller, press the [ZONE 2] REMOTE MODE button, and then use the [LEVEL-] and [LEVEL+] buttons. On the AV receiver, use the ZONE AV receiver 2 LEVEL [ ]/[ ] buttons. ZONE 2 LEVEL If your Zone 2 speakers are connected to an amp in Zone 2, use its volume control to adjust the volume. To Mute Zone 2: Press the remote controller's [ZONE 2] button, followed by the [MUTING] button. To unmute Zone 2, press the remote controller's [ZONE 2] button again, followed by the [MUTING] button, or adjust the volume for Zone 2. Notes: • Only analog input sources are output by the ZONE 2 LINE OUT and ZONE 2 SPEAKERS terminals. Digital input sources are not output. If no sound is heard when an input source is selected, check to see if it's connected to an analog input. • When the ZONE 2 SPEAKERS terminals are used, listening modes that require surround back speakers, such as Dolby Digital EX, DTS-ES, and THX Select2 Cinema, are unavailable. • While Zone 2 is on, the functions do not work. • You can't select different radio stations for the main room and Zone 2. The same radio station will be used for both. 84