Onkyo TX SR804 Instruction Manual - Page 83
Powered Zone2 Setting, Using Zone 2, Controlling Zone 2 from the AV receiver
View all Onkyo TX SR804 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 83 highlights
Zone 2-Continued Powered Zone 2 Setting If you've connected your Zone 2 speakers to this AV receiver, as explained in "Using Only Speakers in Zone 2" on page 82, you must set the "Powered Zone 2" setting to "Act" (Activated) as explained here. 1 RECEIVER Press the [RECEIVER] REMOTE MODE button, followed by the [SETUP] button. The main menu appears onscreen. 2 ENTER Use the Up and Down [ ]/[ ] buttons to select "8. Hardware Setup," and then press [ENTER]. The Hardware Setup menu appears. ENTER 3 ENTER ENTER 4 Use the Up and Down [ ]/[ ] buttons to select "Powered Zone2," and use the Left and Right [ ]/[ ] buttons to select: 8.Hardware Setup a.PoweredZone2:NotAct b.TV Format :Auto c.AM Freq. Step: 9kHz d.Remote ID :1 Not Act: ZONE 2 SPEAKERS terminals not activated. Act: ZONE 2 SPEAKERS terminals activated. When Act is selected and Zone 2 is turned on, the speakers connected to the ZONE 2 SPEAKERS terminals will output sound, but the speakers connected to the SURROUND BACK SPEAKERS terminals will not. When Zone 2 is turned off, even if Act is selected, the surround back speakers will work as normal. Press the [SETUP] button. Setup closes. Using Zone 2 This section explains how to turn Zone 2 on and off, how to select an input source for Zone 2, and how to adjust the volume for Zone 2. Controlling Zone 2 from the AV receiver 12 STANDBY/ON POWER STANDBY ZONE 2 ON OFF PURE AUDIO MULTI CH DVD VIDEO 1 VIDEO 2 VIDEO 3 VIDEO 4 TAPE TUNER CD PHONO DISPLAY MASTER VOLUME PHONES ZONE 2 OFF TONE ZONE 2 LEVEL STEREO TUNING DIMMER MEMORY MODE SETUP RETURN ENTER SETUP MIC LISTENING MODE CLEAR PRESET PRESET TUNING DIGITAL VIDEO 4 INPUT S VIDEO VIDEO L AUDIO R 1 ZONE 2 2 OFF To turn on Zone 2 and select an input source, press the [ZONE 2] button repeatedly. Alternatively, press the [ZONE 2] button followed by an input selector button within 8 seconds. Zone 2 turns on, the ZONE 2 indicator lights up, and the ZONE 2 12V TRIGGER OUT goes high (+12 V). To select AM, FM, or XM (North American model only), press the [TUNER] input selector button repeatedly. To select the same source as that of the main room, press the [ZONE 2] button repeatedly until "Zone 2 Sel: Source" appears. To turn off Zone 2, press the ZONE 2 [OFF] button. Note: • This procedure can also be performed on the AV receiver by using its [SETUP] button, arrow buttons, and [ENTER] button. 83